Roof rack light wiring

[fdmarshal]

Where does everyone run the wires from a roof rack mounted light bar?

Thanks!

 

[Trunk Monkey]

Don't know about everyone, but I think the most common is down the A-pillar along the windshield then under the hood.

 

[Cruiserlab]

Yes, and I think you can get trim pieces that the wires run through to hide them. Sticks down to A piller trim.

 

[fdmarshal]

Yes, and I think you can get trim pieces that the wires run through to hide them. Sticks down to A piller trim.

That would be ideal. Hopefully someone chimes in! Or is this in the wrong section? I saw a lighting section after i posted!

 

[96bruizer]

I used a smilier bulkhead for my roof lights...This is truly the cleanest way to wire lights to the roof. but it's permanent.
https://www.amazon.com/dp/B0BNB97STB?tag=ihco-20

 

[CORunner]

If you wrap the wires in wire loom it will hold itself in with friction. You can also wrap the loom with a few wraps of electrical tape to make it wider to get a better friction hold.

 

[Cruiserlab]

Universal Wire Hider

www.kchilites.com

Universal Wire Hider - https://www.kchilites.com/universal-wire-hider-kc-6300.html

 

[Exiled]

@Cruiserlab beat me to it, I was going to recommend the KC Hilites wire hider, it's a very practical and elegant solution and not terrible expensive for what you get. I've been running this stuff for years.

 

[cbbr]

@Cruiserlab beat me to it, I was going to recommend the KC Hilites wire hider, it's a very practical and elegant solution and not terrible expensive for what you get. I've been running this stuff for years.

Same - works great on our LCs and 4Runner.