Rollover question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 10, 2009
Threads
44
Messages
286
Location
Decatur,AL
How susceptible would the rear axle housing be to getting bent during a highway rollover? I know this is one of "those" types of questions but I am looking at buying an axle out of a rolled truck and since I don't have first hand knowledge of the strength of these axles I was looking for some input. How could you tell if it were bent unless it very obvious? The guy at the salvage yard said he would have to take it out of the truck and check it but I don't how he would do it.
Thanks
John
 
Well there have been a few documented roll overs here. And a few that are still driving them. A roll over from on off-camber position I would not worry much. A mutli-rollover from a vehicle doing 60mph+ I would probably walk away from it.
 
Last edited:
High-speed rolls usually bend axle housings. Soft flops usually don't.
 
Back
Top Bottom