Rods and pistons

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 21, 2008
Threads
31
Messages
289
Location
Marshall, MI
I am just curious. If I decided to replace the oem rods and pistons with aftermarket ones, what would i have a machine shop do? I would like to have a list of what i need the shop to do and a round about cost for each service being done. I really would like to have an idea before i get lied to by a machine shop. I am also doing this to try to do a cost and comparison to rebuild a 1fz or swap in a V8.
 
The reason i wanted to use aftermarket parts because they will take more boost safely. IMO if a person is spending x amount of dollars to turbo or supercharge, why short change your investment with internals that you know will not hold the boost that you wish to perform at. Like i said before , this is just a cost and comparison.

After reading posts on supercharged and turbo installs, everybody is happy with there new found power. But i cant recall once anybody saying this is better than a V8. I feel if these installs had upgraded rods and pistons, people wouldn't want V8's. Saying that i wish to see which is cheaper to obtain.
 
I can't find the thread but there is a fellow in Australia that is running a 1FZ in an old MarkII hardtop drag car. It has a HUGE turbocharger on it and the guy runs a stupid ammount of bost (20+lbs if memory serves) with a completely stock bottom end.
 
That's the car. A Crown, not a MarkII.
 
I have read that post. That is very impressive. But what i have read on this forum is everybody seems to stay around 7psi. This tells me that nobody thinks the engine will hold at 10 psi or more for DD reliability. Am i wrong?
 
The challenge is the head gasket and fueling it properly.
 
The challenge is the head gasket and fueling it properly.

x2

MLS or copper head gasket and head studs and the limit is then the fuel(detonation). If you could tune spot on with a standalone ecm, I don't doubt that the parts could physically handle 20psi (intercooled-400 to 500hp levels)with a safe redline. Boost wont kill the motor, rpm would though. The oil cooled pistons (although cast) are good ones with a lot of beef around the rings. Rods have plenty of material also. Ive put way more to way worse enginered powerplants. These 1fz's are beasts of burden.
 
If you're going to go above 400hp, I would go with forged pistons and rods. I come from the Supra world and I've seen some high hp Toyotas. 400hp is really the safe limit on non-forged stuff. Yes people have gone above that on stock cast stuff, but I don't recommend it. As far as brands, Diamond, Mahle, Speed Pro, JE, Manley, Federal Mogul all have good reputations of holding up to 800hp.
 
Back
Top Bottom