Retiming Lx470

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 17, 2016
Threads
28
Messages
128
Location
Baton rouge
Have a 2002 Lx470...swapped blown motor out with a low mileage 4.7...don't know exact donor vehicle...Paid for the swap work, mechanic also put new timing belt, water pump, seals etc...
It's out of time and I'm fixing to redo it myself.
I've read all the write ups, I'm very good mechanically but have never done a timing belt...write ups are pretty straightforward on just swapping out belts but not with actually retiming...
Help Please
 
It’s the same process. You have to remove the belt, at least partially, to get it back in time. Why do you think timing is off?
 
And if it is out of timing why not take it back to the guy that did the work? A TB job is a good day's worth of work if you know what you're doing, and could be double that if you don't.

Jim
 
So i just did this on my LX, the passenger side of the motor jump 2 teeth on the belt causing a rough idle and misfire. im lucky it didnt go any further because it would have done internal damage. if it is actually off, take the belt off set everything to Top Dead Center (TDC) and reinstall the belt. Turn the motor over clockwise by hand slowly to insure everything is moving freely, then reassemble
 
And if it is out of timing why not take it back to the guy that did the work? A TB job is a good day's worth of work if you know what you're doing, and could be double that if you don't.

Jim
I had him do it all before he installed used motor, he didn't charge me for doing it, only thing extra I paid for is installing all new seals and such..
 
So i just did this on my LX, the passenger side of the motor jump 2 teeth on the belt causing a rough idle and misfire. im lucky it didnt go any further because it would have done internal damage. if it is actually off, take the belt off set everything to Top Dead Center (TDC) and reinstall the belt. Turn the motor over clockwise by hand slowly to insure everything is moving freely, then reassemble
Mine will start for maybe 10 seconds then die after sitting all night, I've heard and have seen vehicles out of time and this is very similar if not same....its a extra vehicle so going start and finish slowly no rush...just a little intimidated as I've never done this before
 
Did you take off the cam sprocket covers, set it to TDC, and actually check the marks on the cams against the marks on the heads? It's not hard.
 
Back
Top Bottom