Replacement Seat Switch

[Outsane]

@VonLogan I will take a look today

 

[Outsane]

Almost done, and I need a darker brown.

 

[VonLogan]

Looks like you're almost there!

 

[Outsane]

Yeah I think they will do the job nicely!

I also slimmed them down so they do not stick out as far, and brought the back closer to the panel to close up some of the gap.

Landcruiser seat angle adjustment knob FJ80 FZJ80 LX450

Landcruiser seat adjustment knob FJ80 FZJ80 LX450, this is a 3d Printed replacement made of PETG This adjusts the angle of the backrest. This part is also sticks out about about 4.5mm less then the original, So you are less likely to knock it off again.. I hear these make fantastic earnings...

solvefunction.com

 

[ColoradoLC]

Hehe I started this thread a while back, and now I need the post as well. What are people using to replace the posts?

 

[samiam09]

I ordered the switch from Lexus Then Toyota each time was told the switch was no longer available. I order threw a company out of Japan only to be told a week later it was not available.I found Partsoaq they had 10 in stock it arrived a week later , the right switch for the drivers seat. I have tried to order the little knob from Both Toyota and Lexus they keep sending me the wrong part telling me this is what toyota calls for72593-60010EO. needless to say those knobs do not work with the seat in a fj80 or lx450. I have oreded the last one from partsouq we will see if it the right one as of tomorrow.

 

[ColoradoLC]

Did you see the one from SolveFunction above? I just ordered that today and will put it in once I get it, assuming I find the post replacement too.

 

[Oneops]

I have set of switches from a grey set. Motors too. Soon I’ll have the same in the brown except the recline. That’s was missing. I’m putting a new set of seats in and won’t need any of this stuff.