Removing Undercarriage Spray Coating ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 7, 2014
Threads
29
Messages
237
Location
Ohio
So the previous owner of my rig had it sprayed with some sort of coating. Not sure if it's truck bed liner or something else. This crap has mixed with rust/grime etc and it needs to come off. It makes a real pain out of the simplest job.

I've had a little luck with an angle grinder and wire brush but it is very time consuming.

Anybody have any tricks for removing this gunk. Heat, solvent, etc........

Thanks.
 
Getting it dry ice blasted is probably the best way, if that's available to you.

You can heat it with a heat gun or torch and then scrape it off. This works, but it's sticky/messy and using a torch produces some nasty fumes. Be sure to use a mask if you go this route.

There are solvent sprays you can get. They produce a sticky mess you have to scrape off too.

This guy used an oscillating multi-tool, not sure if it would work in your case or not:
Undercoating Removal - The Fastest Method Yet! - Pelican Parts Technical BBS

A grinder does work well, it's slow but so are most of the other methods of removal.
 
I just removed undercoating from my 69 Camaro. Came off super easy with a bottle torch. Heat it till it just before it starts to shine--NO MORE or it starts to smoke and turns to liquid. Scraped off in sheets very easily with a 1 inch putty knife. Don't try a wider one. I probably spent 2 hours on the whole underbody. Simply wiped it with a rag and solvent and I had perfectly clean metal. Not that smelly either.
 
Last edited:
Thanks for the responses. It is old and brittle in most area's with a few spots that are still gunky.
 
Thanks for the responses. It is old and brittle in most area's with a few spots that are still gunky.

if this is the case and you have an air compressor, go get an air chisel. I took the same type of material off of an fj55 and it worked very well.
 
I discovered a couple of tricks when getting undercoating off my Chevelle during resto. First is the above mentioned torch and putty knife, second was to take motor oil and brush it on with a paint brush. I let it sit for a day and it scraped off very easily. It will depend on the porosity of your coating as to how quickly it penetrates, but it's worth a shot. My old undercoat was rock hard. If the coating absorbs the oil it comes off very easily.
 
Back
Top Bottom