Removing Condenser

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Hi guys,

Hopeful for some more AC wisdom from your side.

After about 3 weeks (and cool Boston weather in between), the 134 that I put into the system is suddenly gone... .no pressure at all on the gauges. When I swapped the condenser and receiver/dryer I added dye, and the only residue I see is around the schrader values (both high and low pressure show just a little). I thought this made sense from connecting and disconnecting the gauges but....

We're car camping this weekend in north NH and my 2 and 3 year old aren't going to like 90F on the drive up... it won't hurt them... but they also probably won't sleep.... not horrible... but fixing this mystery AC problem seems possible, but I'm not sure how.

My plan is to 1) replace both schrader valves, 2) add pag oil to the top port on the condenser, 3) replace the receiver/dryer with a new one, 4) vacuum the system, 5) fill up to pressure with about 2.5 little cans of r134a.

Please share any of your thoughts and ideas if you have them. Thanks!
 
If it was me I would use some of the leftover gas from the last fill and pressurize the system then check all your connections you can reach with soapy water. With the engine off stick your ear against one of the Ac vents after pressurizing the system and listen for a hiss, you might also be able to smell the gas inside the cab. If so you can be fairly sure the evaporator coil is bad.
 
Spray soapy water over everything
If it was me I would use some of the leftover gas from the last fill and pressurize the system then check all your connections you can reach with soapy water. With the engine off stick your ear against one of the Ac vents after pressurizing the system and listen for a hiss, you might also be able to smell the gas inside the cab. If so you can be fairly sure the evaporator coil is bad.
 
Replacing the evaporator fixed my AC leak. The 1996 Factory Service Manual shows a different configuration behind the glove box than my 1994 looked like.... felt pretty bold disconnecting and unbolting computers, but it went fine.

No one had ever been in there before, so I guess 21 years is long enough. It looked like a long-growing collection of small leaves had caused the bottom of the evaporator to oxidize/rot/whatever. A new one was about $80 and took a few hours to replace. Maybe I'm getting better at working on the Land Cruiser, but the evaporator seemed a lot easier to replace than the condenser (a few months ago).

Tested it first with an air pump and it built up and held pressure on the gauges... tested it again with a vacuum that held for 24hrs... then added PAG45 with UV dye into the top of the compressor, swapped in a new dryer, let the vacuum pump suck for an hour, charged it up to 35 psi (low) and about 150 psi (high), and it has been almost a week and the AC is still blasting cold!

Happy wife happy life! I wish all things were this simple!
 
Back
Top Bottom