Recurrent oil/antifreeze problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 12, 2017
Threads
8
Messages
64
Location
Fort Morgan, CO
have a 91 with 3fe with hg problems as told to me by P.O. I have been googling a bit as I’m new to the platform.... found a couple threads with (found water in oil) back in 2013 with no culprit.

It worries me as I am seeing signs that this has been a problem before on my vehicle. (Color coded Wires on vac lines, yellow coolant, P.O. who is diesel mechanic reluctance to fix it and keep it)

So my question is, after taking it apart and doing all the work and effort on a hg job, and you don’t fix the problem, what does it end up being?
 
Cracked head! I saw a thread on it before. Common on some later 2F and 3F motors.
 
What evidence (besides the PO) do you have that you have a failed HG? Compression test? Magic bubble radiator test? Steam cleaned plugs? Losing coolant?
 
Cross-contamination in the oil cooler is an under-the-radar culprit for 3FE's.

No point tearing into the motor until you've done some thorough diagnostics.

What symptoms are you seeing?


^^^^^^ Agree. Oil cooler (if no other issue is found) is an easily overlooked source.
 
I mainly asking about folks that redo everything twice, what was it typically at root? Cracked block or using non toyo gasket?

As far as my sitch goes, oil level is hi and contaminated, radiator is low, was blowing sweet white smoke when I backed it into garage, and previous owner said it was hg. I assume he lost power. I could never get him locked down on why he thought was hg. But he’s diesel mechanic so I assume he has some sort of idea.

I don’t have comp tester, the gas detector and the radiator isn’t milk shaky so I don’t assume it’s the oil coolers fault
 
Kinda started already. Removed air pump and egr. That stuff prob gonna stay off no mater what’s “wrong”. I was kinda hoping I would run into some locals on here who Could help a brother out...
I don’t wanna buy all the trouble shooting tools, by the time I do that I’m already into it for cost of the gasket...
 
I guess I’d do a couple of things. Send an oil sample to Blackstone Labs. They will tell you if there is coolant in the oil. Cost $28.

Go to a parts store and rent the compression tester. Pull plugs and see if they are steam cleaned.

I wouldn’t assume anyone is competent in identifying a HG failure on a 3FE unless they know these specific motors.

The 3FE is insanely durable and rarely has HG failure. It is very rare.

Hell its rare on the 1FZ-FE even though it is made out to seem like every one is a ticking time bomb.
 
Slow down.
 
I mainly asking about folks that redo everything twice, what was it typically at root? Cracked block or using non toyo gasket?

As far as my sitch goes, oil level is hi and contaminated, radiator is low, was blowing sweet white smoke when I backed it into garage, and previous owner said it was hg. I assume he lost power. I could never get him locked down on why he thought was hg. But he’s diesel mechanic so I assume he has some sort of idea.

I don’t have comp tester, the gas detector and the radiator isn’t milk shaky so I don’t assume it’s the oil coolers fault
Classic symptoms of a blown head gasket. It's possible the head could be cracked, but either way the head needs to come off. An oil cooler issue isn't going to send steam out the tailpipe. Pull the plugs, look for one or more that are very clean. In the end, there aren't any clearer clues than a combination of contaminated water/ oil and steam out the tailpipe. Usually there will be a bad miss and loss of power as well, if it runs at all.
 
I have the black stone jar already but haven’t sent sample yet cause I tryin to be cheap. What else would be in there? Transmission fluid?

So how often do folks pull heads unnecessarily around here?
 
Classic symptoms of a blown head gasket. It's possible the head could be cracked, but either way the head needs to come off. An oil cooler issue isn't going to send steam out the tailpipe. Pull the plugs, look for one or more that are very clean. In the end, there aren't any clearer clues than a combination of contaminated water/ oil and steam out the tailpipe. Usually there will be a bad miss and loss of power as well, if it runs at all.

Sure, but it sounds like the OP is going more from the PO's word than doing his own research.

Remember how every fall we get a rash of folks falsely thinking their HG's are going out as temp's cool and their exhausts start condensing?
 
The reason folks here are stating to slow down is because the 91-92 version has the 3FE engine that is MUCH less prone to HG problems versus the 93-97 version with the 1FZ-FE engine.

Unfortunately, folks unnecessarily pull heads occasionally, especially on the 3FE because they don't understand that everyone else is obsessing about the 1FZ-FE engine, or they have no idea what they're doing.
I have actually STOPPED a guy that was halfway into the HG tear down on a 3FE because he had convinced himself that he had a HG issue. He ended up screwing it up more than he fixed it because he had no idea what he was doing.

That being said, if you are truly blowing sweet, white smoke out the exhaust, the the HG or cracked head issue is more likely.

Definitely diagnose it before you yank the head.

Compression test (Borrow tools from Autozone / O'Reilly)
Inspect Spark Plugs (No cost)
Exhaust gas test on the radiator (Buy a kit from local FLAPS for approx $20)
Blackstone Oil analysis. (Approx $25)

The above doesn't cost much except a bit of time on your part or waiting for Blackstone.

If you have looked at the water condensation on the bottom of the oil fill cap, it means nothing.

Don't go cheap or you'll end up redoing it. Buy Toyota head gasket sets, not FelPro or equal. Those have been proven out here to be problematic.
 
If you are trying to be cheap then I would recommend posting your Land Cruiser for sale and walking away.

If you aren’t going to listen to experienced, knowledgeable advice, then why are you here?

Spend the $28.

The compression test is free. Go to autozone or O’Reilly and “rent” it. You pay and get your money back when you return it.

Stop guessing. Find out what is wrong. Then make an educated decision.
 
So how assembled does it have to be to do compression test?

I have inspected all plugs and only 6 is diff than others. It’s more oily than steam cleaned but it wasn’t driven on long. Maybe just the reversing into my garage.

So what’s the source of the cold weather problems for the 3fe guys? I’m all about listening to advice but my questions aren’t being answered. Not trying to sound ungrateful or deaf ear ish I just trying to get caught up to speed...
 
So what’s the source of the cold weather problems for the 3fe guys?

Huh?

If you're referring to my comment about steam in the exhaust, I was just noting that's normal for a few minutes when it's cold out, yet lots of folks freak out about it cuz they're so paranoid. If you're really sure it was more than that, then yes, your HG is toast.
 
Back
Top Bottom