Rear Wiper Motor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 17, 2008
Threads
6
Messages
28
Location
Erie PA
Im new here and im sure someone coverd this at one point but I have a 96 LX450 and the rear wiper quit working. I opened the back end up and saw lots of rust on the wiper motor, Im assuming its shot and I was going to buy a new one from SOR.com Before I spend the non-refundable ~$100 can anyone confirm that the FJ-80 motor will work in the LX450? I know many of the parts are interchangable but I thought I would just check to be sure.
Thanks!
Nick-Newbie...
 
Take your rusty motor out, open it up and clean the thing up it will work...

Apply lots of pressure to your screwdriver and or you vise grips.

Mine was full of rust and crap being a 93 on top of the years we also deal with road salt from November to April.

When putting it back together dab some grease around the wiring and any other surfaces you want as added protection.
 
Thanks!

Hey thanks alot for the advice. I will give it a shot before I purachase a new one.
 
Thanks I will keep you posted if I cant get mine running again.!
Nick
 
Two phillips screws on rear door handle, pull the plastic cover off it is held in with grommets.

Motor is held in with three bolts, remove these, disconnect wiring and your motor will come out with minor manovering.

Takes less than 10min.

Clean, lube, reassemble and test before re-install.
 
I found a Hoffman electrical panel plug was much easier to maintain than the wiper I never used. They have a wing-nut on the inside, foam gaskets, very simple mod. Try any electrical supplier.
Sell 4.webp
 
Back
Top Bottom