Rear windshield leaking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 15, 2014
Threads
5
Messages
16
Hello all,

I have a 1991 FJ80. I discovered a small leak on the rear windshield on the bottom passenger side corner. It appears that water is running down from the outside and coming from under the glass to the inside. Water is accumulating on the little lip on the inside of the windshield in the cargo area. It has been raining the past few days but nothing severe.

What are my solutions to this? I am going to take the car camping in the next few months and I don't want this to be a full blown problem when out there. Replace whole gasket? How bad/big of a job is this?
 
You may need a new gasket and you may have lots more rust under the old gasket. Get it fixed soon. I have a spare hatch sitting here that is so rusted out in the corners under the glass that the only value to me is the glass itself. The hatches seem to grow rust really fast once it starts, so I'm guessing here was no corrosion protection on them?
 
You may need a new gasket and you may have lots more rust under the old gasket. Get it fixed soon. I have a spare hatch sitting here that is so rusted out in the corners under the glass that the only value to me is the glass itself. The hatches seem to grow rust really fast once it starts, so I'm guessing here was no corrosion protection on them?

Thanks, I will check into getting a new gasket ASAP. Car was purchased from old couple, so it is totally stock with a little frame rust. I assume there aren't any form of corrosion protection.
 
Just purchased a gasket from Beno and replaced my rear glass two weeks ago. I used 3M urethane caulk that I purchased from NAPA ($28 tube!) and tackled it in a few hours. Follow the FSM, it is installed the same way that the front windshield is, and using a chord around the gasket to pull it over the pinch weld is the only way to do it. It seemed like a bitch, but once it got started, it went around the whole gasket easily. Make sure your window is centered before you start.
 
Back
Top Bottom