Rear shock mount -- Sheared OFF!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 3, 2008
Threads
39
Messages
148
Location
Logan, UT
Was working on putting stock height OME coils on the rear when the resistance I felt in the (Liquid Wrenched) lower mount for the shock sheared off. :bang:


Is the best way to deal with this (on a '96 LX 150k mi, some East Coast corrosion) to tap it out or....?

Also wondering if the stock LX shocks are softer than the pair of NIB FzJ80 shocks I have. Thought I might replace them while at it.

RTC
 
So you sheared off the bolt...or the mount?

If the bolt, an easy out is probably going to be the ticket. You could also try welding on a nut.


The stock LX shocks are softer than the LC shocks.
 
You can drive it with that one rear shock out. No big deal.

I would not drive it very far without both rear shocks. Feels like a roller-coaster ride. Very bouncy. In a pinch/emergency I wouldn't hesitate, but I'd avoid it if possible.
 
put some anti-sieze on those bolts before you torque them down. I know this does not help you with the current situation, but it will help in the future when you have to remove the shocks.
 
I would not use anti-seize myself. There's only a few parts I can think of where I'd use it (the cone washers would be one). Partially because it changes the torque spec (wet vs dry, much easier to snap with a wet spec), partially because I don't want certain bolts (like the shock mount) coming out....

Besides, if a bolt snaps there was something wrong with it. It needs to be replaced.
 
Yea, this was actually a Boston rig once upon an owner. Hence the rust.

The good news is OME's are going on at the same time, so I'll try to ignore the cost of them getting the bugger out. Perhaps a FOR lift will go on before the new bolts have time to rust....
 
Back
Top Bottom