Rear diff lock light stays on

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 11, 2013
Threads
47
Messages
229
Location
Burbank, CA (SOCAL)
So I just swapped a rear axle with a locker one. Wired up everything as correctly as possible which looks to not be the issue. I finally installed the dash lights thinking it could help me figure out why switching the rear diff causes only the relay to turn on but not the motor. With the car on, the rear diff light stays on. Any ideas? As far as I can tell, it doesn't seem like the diff is locked since I'm not getting any tire noise while turning.

If I were to take a random shot in the dark, I would guess perhaps the position sensor is broken and thinks its locked but I really have no idea how this system works.
 
Last edited:
If the position sensor were locked it would still try to engage the locker if you turned the switch back to the correct position.

How do you mean you wired everything up as correctly as possible? what year truck? did you get the complete floor harness and rear underbody harness?

Toyota moved a few wires around on the floor harness plugs depending on year and LC/LX so it is possible you have some pin locations wrong.
 
If the position sensor were locked it would still try to engage the locker if you turned the switch back to the correct position.

How do you mean you wired everything up as correctly as possible? what year truck? did you get the complete floor harness and rear underbody harness?

Toyota moved a few wires around on the floor harness plugs depending on year and LC/LX so it is possible you have some pin locations wrong.

I built a 5 wire harness going from the axle harness directly into the pins on the drivers kick panel plug. As far as all the info i could find and was given from my previous inquiry, I wired it correctly. I'm not exactly sure what voltages I should be getting at each pin thoguh when the locker is turned on. The only voltage I was getting was a pulsing voltage at one of the pins. I don't remember which pin at the moment. What are the voltages at each pin supposed to look like when turned on?
 
I'm not sure and don't have an EWD in front of me. My knowledge mostly lies in factory wiring.. afraid I can't be of much help at this point.
 
I'm not sure and don't have an EWD in front of me. My knowledge mostly lies in factory wiring.. afraid I can't be of much help at this point.

yeah i'm guessing at this point, I should dig back into that plug and list out which color wires are going into which slot in the plug just to get other sets of eyes making sure I got the wiring right.
 
If the position sensor were locked it would still try to engage the locker if you turned the switch back to the correct position.

How do you mean you wired everything up as correctly as possible? what year truck? did you get the complete floor harness and rear underbody harness?

Toyota moved a few wires around on the floor harness plugs depending on year and LC/LX so it is possible you have some pin locations wrong.

you nailed it, pin locations were wrong, took a look at a buddy's truck with factory lockers and figured it out. Thanks for the help! honestly made it like a 1 hour fix.
 
Back
Top Bottom