Rear Axle FSM Section?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

supercarrera

Club Esprit de Four
Joined
Dec 20, 2006
Threads
117
Messages
1,108
Location
Santa Clara, CA
Website
www.instagram.com
Hi,

I need to pull one of my rear hubs to change out a wheel lug stud that's messed up. I'm looking through the FSM that I downloaded and for some reason, I'm missing the rear axle section. From the write up in the FAQ, it looks very simple, but I would like to have it for torque specs and anything that's not covered in the FAQ writeup. Can anyone send me a copy of it (rear disc brakes)? I don't think I'm breaking any rules since I paid for it already. If it's not cool, then let me know and I'll try to download it again...
 
IIRC just remove the drum/disc and the studs plus their mounting surface will be exposed. That's as much as you need to dissasemble. Just drive the old stud out and put a new one in. Torque should be whatever you normally use for your wheel nuts.

Jon.
 
I ended up downloading the missing section. It looks like you need an SST to remove the axle bearing lock nut. What's the story with that? I'm assuming it's possible to remove without an SST?
 
There are a number of posts here regarding making or using alternatives to the SST. IIRC you can you a Dana 60 hub socket. I bought the SST from CDan and it was a breeze. You'll need a heavy brass hammer and a brass drift to get out the cone washers.
 
Back
Top Bottom