NLFS Random Archived Classifieds

[schlaker]

Rear Hard Top chanel/bracket thing

Looking for the piece that fits just above the rear lift gate on pre 75 hard tops. The part that the hinges atach to. It joins the two side pannel together. Need one that is not rusted out, and has side tabs still intact.

 

[macgyverFJ62]

TPI Smokey Mt. 60 lift kit or OME

I'm looking for a used lift kit
pm me or reply

 

[Benjitis1]

FJ-40 front axle with disc brakes

I need a disc braked front axle for my FJ-40. I also need a SM420 speed transmission. Im located in Gig Harbor, WA

 

[IDave]

3 Speed Transfer Case Front Drive Cone

My transfer case has a leak, and I believe it is because it has an ear missing (and therefore one less bolt) from the front drive housing cone. I'd like to replace it, I am not a welder yet, and I was hoping someone with a cracked case lying around would have a front drive cone from a 3 speed to spare.

 

[zebrabeefj40]

SM465 needed in Cincinnati/Indy area

Looking for an SM465 in the Cincinnati/Indy area. Need a bare trans case at minimum to set up a V8 conversion. If you have an SM465 with an aluminum top cover and the shifter mounted way to the back of the cover let me know...that's the baby I hope to have for the final install!!!

Let me know what you have...

TIA,
Nick Jennings

 

[mathblaster]

4 speed transmission near Minneapolis

I'm looking for a 4 speed (H41) transmission for a swap. I might need drive shafts as well. If you got one and your near Minneapolis let me know.

 

[Gumby]

Got one in Chicago.

 

[Gumby]

I've got a 2wd with the cast iron shifter mount from an 84 C-10. It would need the tail shaft changed for a 4wd application.

Yours for the taking in Chicago or I could meet you in Attica next time I'm down there.

 

[zetasig]

I have a used one from a 68 Fj 40. It worked when I pulled it about 2 years ago. I will have to dig it out.

Whats a going rate for one of those.

Shipping from Columbus OH.

 

[3_puppies]

still need one? I can pull one off of my 65.

 

[cosmo]

Still looking? If so I can help Ya out.

 

[macgyverFJ62]

bump

 

[macgyverFJ62]

bump

 

[IDave]

Sure do!

PM'd ya.

Dave

 

[Pinion]

Need: Vac advancer for ~79 and up

The diaphragm is shot on mine and wont advance under acceleration. Looking for one that works.

Thanks!

 

[wesintl]

Try www.nardek.com they have new ones and shipping is very reasonable and so it the time frame on AUS postal air.

 

[weigellj]

Got a 4 speed/tcase setup out of a fj60 in central WI. Not sure what type it is. Email me for more info

 

[66fj40x2]

Sorry, I'm located in the Wichita, Kansas area. :whoops:

 

[Coyote]

1987 FJ60 Parts

I'm in Fort Collins, Colorado and looking for a driver side fender, hood, front valance, for a 1987 FJ60. Perferrably silver. Email John @ coyotecruisers.com-thanks

 

[McGruff44]

FJ40 Radio Opening

FJX