Radio wiring help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 5, 2015
Threads
21
Messages
243
Location
Georgia
Can someone tell me how to connect this radio. I assume the male spade is power and one of the other 2 is speaker but want to make sure before I try it out to see if it works. Thanks
20190708_090621.webp
20190708_081820.webp


I will be connecting it to this speaker
20190708_081853.webp
 
looks oem.. id update it to get better sound. I have what I used in my 77 build thread, its way louder.

Thanks for that information. I just looked through your thread and found it. I'm sure the sound is in fact much better.

Thanks for the picture. Looking closer at mine I see two wires going in to the sheath, but only one coming out. I'll try the radio with another speaker and sort out the oem speaker later.
20190708_133728.jpg
20190708_133742.jpg
 
You are correct. The male spade is the “hot” power in. The metal case of the radio serves as the ground when it is mounted in place and in contact with the metal of the dash. Hope that makes sense, if not let me know and I’ll shoot you some pictures. If you bench test it, connect the power to the spade and the ground wire to the metal case.

Also, the 2 bullets connected to the wire attached to the speaker do attach to those two prongs on the back of the radio that you have circled in your first picture.
 
Thanks for that information. I just looked through your thread and found it. I'm sure the sound is in fact much better.


Thanks for the picture. Looking closer at mine I see two wires going in to the sheath, but only one coming out. I'll try the radio with another speaker and sort out the oem speaker later.View attachment 2024169View attachment 2024170



That is not a factory wire. That is a shielded wire. They used the outer shielding that normally grounded to prevent interference on the inner insulated wire. Not correct but it will work. What does the other end of that wire look? Cut the outer insulation and see if the shielding is there.

If your looking for a 100% correct radio then would want to use this speaker. Since the wiring from the speaker is not original would remove that wiring and check the ohms on the speaker.
 
Back
Top Bottom