radiator mounting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 15, 2005
Threads
59
Messages
661
Location
High Desert, SoCal
Hi All
Still monkeying around with my ps steering conversion. Finally got the Bob Firestine mounts. I have one mount in and it appears that the engine is much lower than when I was using the front saddle mount. That means that my radiator is now to high. It looks as if the fan will hit the lower rad hose. I am currently using my OEM radiator. What I am looking for is pic, tips etc on how best to mount radiator more to the right and lower it. That would put it closer to being centered and of course move the hose lower to miss the fan. I also have some concerns about the steering shaft clearance if I lower the Rad.

Thanks
Brad
 
Brad, I mounted a plate of steel that sits between frame rails about even with bottom of rails. Nothing to elaborate but radiator sits on it just fine. I would send pic but this service says I can't include attachments. Will send if you give me email address.
 
No pic but I removed the rivets holding the two OE lower radiator supports and moved them to where I needed them (ie eveything in correct right, right/left position) and rebolted them in. Took some time and putting the rad /w shroud in a couple times to get it just right but eneded up just like it's supposed to.
 
Thanks all for the tips, now I have a couple of starting points.
Brad
 
I like them also. Only have one side in, but they lowered the engine about 2" maybe more. The fan hits the lower hose. I really like the way the engine sits now. Plenty of room between the engine and firewall too. The engine also looks like it sets closer to level. Now just have to get the rad to fit again. I think I will move it forward lower and center it. Will have to change the fan also.
Thanks Brad
 
Back
Top Bottom