Quick brake line q

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 22, 2018
Threads
26
Messages
152
Location
WI
96 w abs.

Changing out the two lines going front to rear. Its too cold in my driveway to pull out the old lines right now and with it on the ground I can't see very well. Just going to detach the old and put in the new, then ziptie them together til this spring.

The two lines on each end connect on a vertical bracket. One line is on top, one on bottom. Front and rear.

Is it top to top and bottom to bottom?
 
And how in crazy jap hell am I supposed to reach the fittings for these lines?!?!? Very poorly designed. Oh let's make the bracket just tall enough and long enough that nobody can ever access it again without pulling the entire inner/outer fender or removing the entire power steering system.. What an obvious engineering afterthought

Whether removing the old or installing the new... There is absolutely zero clearance here and nothing can reach them at any angle

Ideas? Please?

0210191034a.webp
 
I’m guessing you’re talking about the 2 lines to/from the LSPV. They’re very tough to get to and just off the top of my head(and my LSPV delete about a year ago), I’d say you’ll have to drop the fuel tank to do it ‘right’. Good luck. I’d just ditch the Load Sensing Proportioning Valve if you gonna F with it at all. Then you’ll only need 1 line going to the back.
 
Looking for the least involved and quickest/cheapest path to get this thing back on the road

The abs and everything has been functioning fine so I'd prefer to keep it all.

Can I ditch the bracket and tees where the rear lines connect in the picture? Maybe just run libes straight from... Wherever the hell those coiled lines go above the bracket

I'm kinda shocked that replacing brake lines requires serious disassembly of the truck. So much for the simple and easy to service engineering..
 
I'm going to cut the bottom lines off the fittings at the bracket, and the whole assembly won't be rigid anymore so I think I'll be able to pull on and stretch the top lines down as they're coiled under the MC and should have plenty of length to get the tee bracket with fittings into the wheelwell for better reach
 

go to page 7 or so and theres a p/n for a t fitting that I used to delete the lspv
 
I might delete the valve when I put new lines and all brakes in this spring.

If anybody runs into this in the future, i was right about getting the lines disconnected.

Disco bracket from frame where fittings join on the inside of it. Cut the lines inside the frame rail near the wheel well. Pull them to the outside of the frame into the wheel well. Pull the bracket with top lines attached down a couple inches into the wheel well. The coiled top lines have plenty of length. Now theres plenty of room to work.

Also, Kroil is really good stuff. I'm impressed
 
Back
Top Bottom