Quantitative Idle Voltage Data

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2003
Threads
359
Messages
6,458
Location
Georgia Tech
I searched but all earlier threads are vague and qualitative with regards to idle voltage.

I need typical system voltages at 800,1000,1200 RPM with no accessories on.

I am trying to diagnose if my alternator (new brushes) is good. It maintains adequate voltage >1200 rpm, but doesn't below that.

I know that typical 80 series' system voltage fluctuates at lower engine speeds, I just need to determine if mine is normal or not.



Thanks.
 
Cruisin;

I have battery voltage and charge/discharge current digitally monitored and this is my scenario:

Cold start:
Voltage is ~14.5 to 14.8 DC
Current/charge (amps) is ~ 70 and decreasing
Idle to 1600 rpm

Warmed engine:
Voltage is ~ 14.2 to 14.7 DC
Current/charge (amps) is ~ 9 to 12
Idle to 1600 rpm

After a 50 mile run down the freeway:
Idling to 1600 rpm
Voltage is ~ 13.6 to 14.0
Current is ~ 6 to 8 amps

I am using the Odyssey 925 batteries. Different batteries will have similar, but not the same readings.

...
 
Ok, this confirms what I was afraid of.

I don't get above 13 v until I hit ~1400, cold or warm.

At idle (high on my truck-800) System voltage is maybe 0.1-0.2 higher than when the truck is off.

Odd that an alternator would make plenty of power (Current x Volt) at higher RPM's but an inadequate amount at low RPMs. Beyond brushes, all other parts for our alternators are way too expensive to be worth it.

Guess I'll either get a OEM replacement from Cdan or look at one of those high amp Sequioa/Tundra alts.
 
Back
Top Bottom