Pumping brakes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 4, 2006
Threads
99
Messages
1,570
Finally got my cruiser out on the road. First let me say this a new vehicle to me and I just did a complete brake job. I have a early 1970 fj40 with the single barrel type master. When I push the peddle down the brakes engage, but if I pump them once the peddle is harder and the brakes work better. So the question is pumping normal or do I need to bleed the system again, thanks
 
try bleeding
 
well if you have 4 wheel drum brakes, thats 2 wheel cylinders per wheel and 8 wheel cylinders in all... i'd say its fairly normal for a double-pump to stop it (thats alot of fluid to move) , although i would rule out all possibilites and have it vacuum bled.

Is there anything leaking? do bubbles form in the res. when you pump the brakes?


if there is an internal or external leak i would fix it because the only thing i like to pump twice is junks momma.
 
The peddle is firm on the way up and I have adjusted the wheel cylinders. I will bleed again and go from there. So am I to assume correctly that one push is all I should need?
 
bandy rooster said:
well if you have 4 wheel drum brakes, thats 2 wheel cylinders per wheel and 8 wheel cylinders in all... i'd say its fairly normal for a double-pump to stop it (thats alot of fluid to move)



It is NOT NORMAL to have to double-pump a properly bled and adjusted brake system, period.....
 
i meant its fairly normal for this to be happening (because this happens to alot of people with all drums). however i do know its not a normal condition under the circumstances of properly adjusted and properly working breaks...


guess i just didn't word it right.
 
bandy rooster said:
i meant its fairly normal for this to be happening (because this happens to alot of people with all drums). however i do know its not a normal condition under the circumstances of properly adjusted and properly working breaks...


guess i just didn't word it right.
:slap: :D
 
My '71 is a double pumper, but I haven't gotten to the breaks yet and I think I have wheel cylinder leaking in the rear.
 
pumping drum brakes

Usually this comes from lack of adjustment.
Run the adjusters up till the wheel locks up
then back off a click or two.
Tightening till it just rubs will get you a pumper.
Adjust, drive, re-adjust, drive. It's a pain, but done properly
those drum brakes work without pumping.
 
Gundy said:
Usually this comes from lack of adjustment.
Run the adjusters up till the wheel locks up
then back off a click or two.
Tightening till it just rubs will get you a pumper.
Adjust, drive, re-adjust, drive. It's a pain, but done properly
those drum brakes work without pumping.
Exactly what solved the problem in mine.
 
damn you guys know some stuff. Adjusted until they rubbed and back them off two turns and wow, one push and a hard peddle. How often do you need to readjust them?
 
i am reading this two days to late. after bleeding, bleeding, then starting all over and bleeding a third time i figure it out. thought that just because the shoes rubbed slightly they were adjusted corectly--not. good luck to all bleeders jim
 
speedn3 said:
damn you guys know some stuff. Adjusted until they rubbed and back them off two turns and wow, one push and a hard peddle. How often do you need to readjust them?

you only need to adjust them until you do your disc brake conversion

here's a good writeup on bleeding and adjusting 4 wheel drums. (thanks coolerman)

http://www.globalsoftware-inc.com/coolerman/fj40/15C.htm
(about halfway down)
 
Back
Top Bottom