PTO gear/gearbox compatibility

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2006
Threads
116
Messages
672
Location
under Pike's Peak
I'm putting the 76 trans/tc back together and I also have a PTO gearbox from a 72. I'm wondering if I should throw a PTO gear in the t/c instead of the spacer while it's on the bench.

Would I be preserving the ability to add the 72 PTO later or are the PTO gearboxes different throughout the years?

Thanks
 
That 63-80 compatibility info is exactly what I was looking for. With that, it seems foolish not to install the gear now.

Thanks for the help.
 
the 1972 PTO gear will have 10 splines on the inside to be driven off a 3 speed tranny. A 1976 is a 4 speed, which will require a rarer 16 spline PTO (not often installed in 4sps). These 16 spline are readily available japanese aftermarket from cruiseroutfitters etc.

1981+ use the 19 spline split case PTO gears which are common.
 
isalwaysright said:
I have an '81 - what was the change after '80?
81-newer split T-case is different. It still has a PTO port in the same approximate lccation, but the PTO gearbox for the 1-piece case will not bolt to the split case.
 
I knew that the PTO gear had to be 16 spline-it's on the bench. I wasn't sure about the output side. 63-80 works for me.

thanks
 
Back
Top Bottom