Problems with Headlights

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 15, 2005
Threads
147
Messages
1,164
Location
Anchorage, AK
I have a slee harness on my wife 97 80. She has complained about the left low beam not staying on. I have pulled the plug and cleaned and applied Dielectric grease, but we are still having problems!! It works if you jiggle the plug! Do I need to order a new harness.... or is there an easy fix??

thanks
Ryan
 
I have a slee harness on my wife 97 80. She has complained about the left low beam not staying on. I have pulled the plug and cleaned and applied Dielectric grease, but we are still having problems!! It works if you jiggle the plug! Do I need to order a new harness.... or is there an easy fix??

thanks
Ryan

Is it possible its the bulb? are you sure you are not just jiggeling the element?

Try switching the left and right bulbs.

Also if the plugs are the same as the stock ones and reusable I have a stock one you can have.
 
No, they are brand new bulbs. The wires going in to the back of the plug have quite a bit of play. I cleaned the back of the housing, and coating the back with some liquid electrical tape. It should keep the wire from moving while driving.
Cross you fingers!!!
 
No, they are brand new bulbs. The wires going in to the back of the plug have quite a bit of play. I cleaned the back of the housing, and coating the back with some liquid electrical tape. It should keep the wire from moving while driving.
Cross you fingers!!!

I am gonna run out the the parts rig I have sitting out back and see if the plugs are reusable.
 
Im running the Slee Wiring Harness, so it is different than stock.

Morse,

Factory wiring harness plugs have a removable pin for each and every wire in each plug. This also means there is a locking device built in for each pin. Look at the locking device, and where the pin goes into the plug. There should be no slop in this fit. If there is any, that is likely your problem.

I do not know if the Slee harness builds additional heat, but I doubt it. There are some bright bulbs out there that do build too much heat. I had a set that were really bright, and they went out while driving at night. Later I found out that they were producing too much heat, and burned themselves out.

1. Check connection and repair as needed.
2. Check bulbs for proper application.

There is also verbage on this in Slee's instructions that are downloadable in pdf form from his site.

D
 
I have the same problem but with the high beams. The Slee harness connector is losing connection to the back of the bulb sockets. I rigged up a cheesy way to apply constant tension using mechanic wire. Now, the head lights work as they should.

The high beams are 85 watts Hella bulbs and the low beams are the HIR 55 watts bulbs. Considering how often the high beams are used, I'm surprised that the sockets are loosing their connectivity.
 
Last edited:
Have you checked the ground wires (one for each side) on the upgraded harness? Make sure they have good contact and bolted on tight!
 
Have you checked the ground wires (one for each side) on the upgraded harness? Make sure they have good contact and bolted on tight!


Ground is good. Otherwise I wouldn't have perfect low beams! It is the Slee connector on both high beams that seemed to have loosened up in my case. Strange scenario I admit.
 
Mine were just on the low beam drivers side. The ground is good. I contacted Christo.... and he is sending me a new pair of plug ends!!! What a great business!!! Thanks again Christo!!!!!!

Ryan
 
That's what customer service is all about.
 
Back
Top Bottom