Preload question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 4, 2002
Threads
159
Messages
1,420
Location
Hiding
Well, I searched and saw some different reviews.

I will be putting together the front axle in a few weeks here, after a full rebuild. with the help of the new Club. I have Q78 Swampers, Right around 36" tall. What should the preload be set at with this.

1977 FJ 40 Front axle. with stock Mini Birfs, and asian lockouts.

Thanks a lot.

Warren.
 
I'd be setting it at the higher end of the tolerance listed in the FSM (maybe even a pound or two more). Nope, I don't have it in front of me to tell you what it is. Loosen the 8 screws on the back holding the felts before trying to determine bearing preload though.

HTH,
Nick
 
Nick, would you be interested in making a trip to Columbus in a few weeks, I could give you that oil fired furnace. and some food and some gas $$ to help me put the front end back together. Its all clean, painted.
 
zebrabeefj40 said:
I'd be setting it at the higher end of the tolerance listed in the FSM (maybe even a pound or two more). Nope, I don't have it in front of me to tell you what it is. Loosen the 8 screws on the back holding the felts before trying to determine bearing preload though.

HTH,
Nick
I have done exactly this and never had a problem with death wobble but I am only running little 33's anyway!
 
Back
Top Bottom