power window switch works in reverse

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 18, 2010
Threads
4
Messages
29
Location
British Columbia
Ok this is weird. I replaced my power window motor in the rear doors. Now the left rear power window switch works in reverse.
I push the switch to raise the window and it goes down. I push the switch to the down position and the window goes up.

Anyone had this happen? I am thinking the regulator was in the wrong position when I installed the motor.
 
Last edited:
Sounds like the new motor is wired in reverse. Is it an OEM or aftermarket replacement?
 
Well it's wired in reverse. When I installed my drivers motor (dorman) it didn't have any plugs that worked with the oem plug so I had to splice it. I didn't know which was pos and neg so my first attempt had the results that you are experiencing. Switched the wires and all is normal.
 
You could pull the terminals out of the plug and swap them. Sounds like Dorman just put the plug on backwards.
 
I just use a small nail to push back the clip that holds in the terminal and pull the terminals out. No cutting required. They should push right back in. Basically the same procedure used for the pin 7 mod.
 
I just encountered the reversed wiring problem and used the terminal removal tip above - worked like a charm. Three more windows to go...
 
Back
Top Bottom