Power Antenna Cap needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 6, 2014
Threads
59
Messages
363
Location
Colorado
Website
cannabisforcolorado.com
Does anyone have the part number for the power antenna cap? Its the part that screws around the top of the shaft. Basically holds the antenna shaft to the fender.
Thanks
 
This?
Antenna Nut -.webp
 
Thank you I think its the part that ends in 89102!
 
Thank you I think its the part that ends in 89102!

Yes, that would be the nut/bezel that screws onto the antenna mast section. The other part (ornament) is the plastic 'base'.
See pic of mine below.



Ant nut2.jpg
 
I tried to remove the nut to replace the antenna and it essentially disintegrated and the top part just twisted off. I successfully replaced the antenna but despite my best efforts with a pick I can't get all the bits of the old nut out in order to put the new nut on. Maybe my best course of action is to replace the ornament. Does that have the threads that the nut screws on to? Or will removing the ornament give me better access to remove the bits of the old nut? What's involved in removing the ornament?
 
Back
Top Bottom