Possible knuckle issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Oh and throwaway clothes. After they are soaked in 90 weight, moly grease, brake cleaner, red bearing grease and whatever the F$#&- else you won't be allowed back in the house.

Order up some of the disposables on Amazon, use the boxes to protect the driveway.

@cruiseroutfit has a nice turnkey kit that comes with instructions. Spring for new wheel and trunion bearings while you are at it.
 
@cruiseroutfit for all the parts.

But before this turns into a big bout of frustration, I'd recommend just trying to get one of the cone washers out of the drive plate, and decide after that whether this is worth the while...

It gets rather messy after the cone washers, but that's easily dealt with.

Installing the inner axle seal can be an adventure; haven't tried the Wit's End seal driver yet, but the first time I used the Harbor Freight variety, I mangled the new seal right away. I went back to my trusted piece of wood seal driver, and everything went fine. But since then, I always want one extra seal on the order...

P.S. My 'special service tool' for the cone washer is vise grips, a u-bolt nut from a 1/2-ton Chevy, and a hammer; the Chevy nut fits nicely around the nut & cone washer on the drive plate, and when you strike the nut with a hammer, it distributes the force & vibrations evenly, and that helps to rattle the cone washer loose. The air hammer or brass punch method never worked for me.
 
Briefly Hitting the cone washer with the propane torch then spraying pb blaster worked for me. After that it was just a few hammer taps.
 
Back
Top Bottom