PMS & Nipple

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

great access to the oil filter from the front of the rig and without having to reach up to the block to twist the thing off.

pretty therapeutic in many ways. :cheers: to you!

Yep, it usually is, but I met my match on my FJ62 water pump replacement, which took 2.5 months & was assisted by having our other FJ62 parked alongside for comparison. I have now gotten into the habit of taking pics as I disassemble.

THANX! The fact the FJ80 filter mounts like my Tundra's is a minor disappointment. :hillbilly:

I had noticed a link to this post on Slee's site. The Amsoil kit looks superior to one I mounted on a 92 Toy pickup, which had the hose clamp fittings rather than the AN (?) type. There was always a slight seep.

I used the LARGE Toyota LC filter left over from my FJ62s, but not looking forward to snaking it back out of the LX450. ;)


:cheers:
 
I happen to have a fumoto on mine. Yes I agree that for hardcore wheeling it isn't appropriate. I have never worried about it even with moderate wheeling. But my uses for a fumoto are these.

1. Much easier to take a sample for blackstone.

2. I run synthetic oil and still like to drain a couple of quarts at 4k to freshen it
up for an 8k change interval. Try doing that mess free w/ a regular drain plug

3. If I am going to go on a hard wheeling trip, I like to drain the oil and put fresh
in anyway. That is when I put the regular plug back in. At my next oil
change. in goes the fumoto.

You can use a fumoto whenever you want or use the regular drain plug. It isn't one way or the other all the time. And yes, oil changes are a snap with these. I buy 5 quart jugs of oil and i can set an empty one underneath the fumoto and drain straight into it without the need for a funnel. A few minutes later I shut the valve off and stick a new jug under it and start draining the rest. No muss no fuss.

4xoddic- Excellent decision to find the right tool to help you get the job done.

Buck
 
I buy 5 quart jugs of oil and i can set an empty one underneath the fumoto and drain straight into it without the need for a funnel. A few minutes later I shut the valve off and stick a new jug under it and start draining the rest. No muss no fuss.

Buck

REASON #1 in my book!

After using that pallet & oil drain container, I screwed the cover back on, placed my 5 gal. oil drum in the pallet & poured the 8 qts. out as my prosthetic eye viewed the oil leaking around the cover & into the pallet! :bang::bang:

This is the 2nd oil drain pan I'm sending to the dump this summer. Even lid with rubber gasket couldn't be trusted to seal tightly.

It is much easier loading 4 5 qt jugs into my Tundra than a 5 gal drum, even with only 4 gal of oil. I also don't have to decide at the recycling center if my drum is cleaner than empties = draining mine in 50 gal & spotting my prosthetic jewel with Black Gold.
;)
 
I got something similar from Fram that's on two of my vehicles and does not leak, and I believe I paid about $5 to $10. All it is a plug that on the outside is threaded, you screw in a hose that comes with the adapter. and the oil flows out. Remove the hose end and the flow stops.
 
Back
Top Bottom