Pertronix Ignitor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 2, 2005
Threads
28
Messages
48
I have a Toyota dizzy w/vac. advance that has a Pertronix Ignitor. I don't know what year this one came out of, but probably 78 or 82. To connect it, do I just connect the red/black wires to the coil? I have a semi-transistorized ignition so would that have issues with this ignitor? This is replacing a Delco-Remy.
Also, is it possible to plug the vac. advance instead of hooking it to a vac. line?

TIA,
Rob
1976 FJ40
 
The wires from the the pertronix sender unit attaches to the coil. Red positive, black negative. Are you sure you have an advance dizzy? You cannot combine the semi-transistorized ignition system on your 76 with the pertronix. To make the pertronix work properly, or, for that matter, work at all, the coil feeding the pertronix must have the correct resistance. The LC stock coil, AFAIK, will not work. You need a pertronix flame thrower coil. ~$40, or a coil with the proper resistance. I have been running that system now for 5 years.

Take a look at it here

Pertronix's has a web site with all the details. Google it.
 
cardinal fang said:
To make the pertronix work properly, or, for that matter, work at all, the coil feeding the pertronix must have the correct resistance. The LC stock coil, AFAIK, will not work. You need a pertronix flame thrower coil. ~$40, or a coil with the proper resistance. I have been running that system now for 5 years.

What if I use my ballast resistor and the stock LC coil? I will test the coil just to make sure the resistance is right.

Rob
1976 FJ40
 
I'm pretty sure that I used my stock coil for a while when I first got the pertronix, seemed to work OK. I never used the ballast resistor with the pertronix.
 
Just so I have the wiring right, connected to the positive coil is the red Pertronix lead and the ignition switch and connected to the negative coil is the black Pertronix lead and a ground wire? If this isn’t right, what are all the connections to/from the distributor and coil.

TIA,
Rob
1976 FJ40
 
I don't think that you want a ground wire connected to the coil at all - You won't run. The (-) connection is for the interrupt from the points/trigger wheel only. (Auto ignition 101)
 
I connected the pertronix red wire to the ballast resistor, then ballast resistor to positive coil. Then the Pertronix black wire to negative coil. The starter wire and ignition wire were connected like usual. I am still using the stock coil and ballast resistor, but am bypassing the ignitor (for semi-transistorized ignitions). I plugged the vacuum advance port on the dizzy. The engine started and ran better than with the Delco dizzy. Should I plug the vacuum advance port to the dizzy? Would that hurt the dizzy or cause the engine to not run well at higher RPM/speeds?

Is there a way to find out which year this dizzy went to originally? Part numbers 029100-1231, then 11C 4 are found on the dizzy.

TIA,
Rob
1976 FJ40
 
Back
Top Bottom