Part Time ? again

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

You need a spacer to make the aisin locking hubs work, right?
 
I has been a good long term solution for me, go on 5 years this way. I run mostly AWD in the winter. 2 wheel in the summer, spring, fall and long good weather trips. AWD is prefered by the wife. It only take me 15 min or less to install and pull the D-shaft. Handling is better with AWD, but I an not out racing the truck or hitting the corners hot, truck just weights too much.
Some friends that have tried my truck in 2x do not like the way it handles, other do not mind. I young still, maybe when I get in my 80's it will be come more of a hassle to change out the D-shaft. I do not think I would like to have the drive shaft under the truck with only one side attached, sound like a problem, as for the disconnects, most I have seen are 3-4 inches thick, and that would compermise the drive shaft angle.
Good luck on the choice.
 
Through talking with Land Speeder here in Auburn and listening to everyone's advice I have a pretty good idea of what is and what is not affected with this Ptime kit. I am going to get the hubs first and wait on the other parts to arrive at Slee since he doesn't have them in stock. Then d/c my front driveshaft temporarily until I can get the remainder of the kit. I'm mostly going to drive on the road with the occasional off-road trip maybe once a month. I'll probably tow from time to time and this kit just makes since to me. I have had vehicles before with no ABS namely an 01 Tacoma and I didn't even miss it. Also I hear there is a good bit of increased power which brings me back to towing and better mpg. I'm also not going to worry about replaceing the U-joints in the front shaft for awhile since it's not going to be turning or then again I might just do it while I have it off the truck. Then there's the less wear on the front axle. Figure I might be able to double the time between front end service and not have to worry about greasing the knuckles every oil change either. I think if you off-road a lot you'd be better served to leave the truck as it is but if not you'll be better off in the long run going Ptime.
 
Back
Top Bottom