Hi Guys,
new to this forum,
I have an 1990 80 series cruzer 300k on the clock, stock povo pack.
I have just had the 1hz rebuilt, total overhaul, new bearings pistions etc and an aftermarket Denco turbo fitted.
Great upgrade, still only 3k after the build was done.
I have an issue with startup oil pressure after leaving the rig overnight.
I have oil guage and oil light indicate no oil pressure for about 5 to 6 sec after startup.
after this time when cold idle is 25psi and full noise70psi.
When warm idle 12psi and full noise 50psi.
Any help or insight would be much appreciated.
Cheers,
Dan
new to this forum,
I have an 1990 80 series cruzer 300k on the clock, stock povo pack.
I have just had the 1hz rebuilt, total overhaul, new bearings pistions etc and an aftermarket Denco turbo fitted.
Great upgrade, still only 3k after the build was done.
I have an issue with startup oil pressure after leaving the rig overnight.
I have oil guage and oil light indicate no oil pressure for about 5 to 6 sec after startup.
after this time when cold idle is 25psi and full noise70psi.
When warm idle 12psi and full noise 50psi.
Any help or insight would be much appreciated.
Cheers,
Dan