Ohh the fun

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 11, 2019
Threads
4
Messages
131
Location
Knightsen ca
Finished rebuilding my 1fz fe put in back in the cruiser, bolted everything back onto the motor filled all the fluids started the up the bad boy and it fired off and started running after just 3 cranks......ohh so quiet it just purrs. As I start inspecting the engine for leaks oil, water, nothing seemed to be leaking, then I spotted it gas just squirting out of the tops of the injectors. So now I have to start removing the parts that I just put on and see why the leaks are happening.
 
O rings not seated? Mayby you put to much gas in?
😆 Congrats on the rebuild, get it sorted and share your break in results!
 
at least it didn't start dry of oil and screech to a halt....
 
Thanks, ohh rings in the mail and tonight it comes apart. A suggestions on getting the o rings seated on the injectors? When I put them in I did it on the bench thought I did correctly. Any help would appreciated.
 
O rings not seated? Mayby you put to much gas in?
😆 Congrats on the rebuild, get it sorted and share your break in results!
The hole in the injectors looks so small I’m going to drill them bigger should let more gas through them it will stop leaking I’m sure of it just to much pressure🤪
 
Use spit, or a o ring lube called slyglide, go slow on each one.
You should be able to turn them in place, carefully to adjust final positioning.
 
I can't speak for the cruisers injectors, but in the past I've used a /LIGHT/ coating of Shin-Etsu Silicone grease on the O-ring and found it worked great (It had it laying around).
 
Back
Top Bottom