Odd noise upon acceleration after deceleration.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 16, 2014
Threads
17
Messages
70
Location
Idaho, United States
If I am cruising 35 in town 65 on the highway, any speed really, when I am feathering the throttle on and off to maintain speed and distance, the drivetrain will thunk upon acceleration. I am Assuming this is worn U-Joints. What thinks all you fine Men and Women? TIA
 
That would be my guess
 
My first thought would be worn splines on the birfs and drive flange at the hub.

Easily checked. Jack one front wheel of the ground. Pop dust cover off the hub, and the c-clip off the end of the birf. rock wheel back and forth and look for excess loose play at the birf/drive flange.

There's lots of leverage on this connection IMO
 
I would remove the drive shafts, test the u-joints for rotational smoothness, replace if needed and then grease the slip joint splines with moly. Lack of grease in the slip joint splines will create a loud pop when letting off the throttle.
Bad u-joints typically give you a grrrr/vibration on deceleration or a ticking/vibration if accelerating.
 
Upon inspection this evening, the U joints seem tight, the rear Drive moves as one unit and has a "normal" amount of slack that I would expect between the gears on either end. The Front, however, has more slack and has some extra clicks at the transfer case. the two pieces that make up the telescoping bit seem solid. The front, driveshaft seal is leaking as well this is new, as I fixed an engine leak this summer. What could the slack be at the transfer case?
 
Upon inspection this evening, the U joints seem tight, the rear Drive moves as one unit and has a "normal" amount of slack that I would expect between the gears on either end. The Front, however, has more slack and has some extra clicks at the transfer case. the two pieces that make up the telescoping bit seem solid. The front, driveshaft seal is leaking as well this is new, as I fixed an engine leak this summer. What could the slack be at the transfer case?
"Front drive shaft seal"?
 
I have the same issue , I removed the driveshaft and put the locking hubs on unlock , the noise is the same , so I decide replace the rear output shaft transfer bearing , still the same . Next step tear down the t case and see what’s going on
 
I greased the zerks on the front and rear driveshafts and that solved the thunk sound. I also had a clicking sound on acceleration. The sound would go away occasionally when I added more grease to the ujoints. I removed both front and rear shafts to inspect the ujoints. Both seem to be very tight.

Since they have almost 300k miles on them I decided to take it to the driveline shop to install new u-joints and balanced . This solved my problem completely.
 
I greased the zerks on the front and rear driveshafts and that solved the thunk sound. I also had a clicking sound on acceleration. The sound would go away occasionally when I added more grease to the ujoints. I removed both front and rear shafts to inspect the ujoints. Both seem to be very tight.

Since they have almost 300k miles on them I decided to take it to the driveline shop to install new u-joints and balanced . This solved my problem completely.

If grease fixes it, it's usually a temporary bandaid on overdue PM
 
Back
Top Bottom