No Power Steering.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 10, 2004
Threads
24
Messages
767
Location
Northern New Mexico, Espanola
I was driving my 80 in Town yesturday when the power steering just stopped working inthe middle of a turn. I have no leaks or whine's from the power steering pump and the fluid level is good. Is there anything else to check before I buy a new PS pump.

The specs: 1995 FZJ 80 with 166,000 miles.

Thanks,
Vince
 
You just had someone replace the crank seal.

I bet the crank pully bolt is loose. You probably have low oil pressure as well.
 
Check to make sure your pulley belt isn't broken.:)
 
If Dan said is correct, then you more than likely have a loose pulley bolt. The gear on the crank is not keyed to hold it in place. It needs the bolt to be torqued to have it stay in place to drive both the oil pump and the powersteering pump. There is no belt to drive the P/S pump on the 1fz engine. later robbie
 
You just had someone replace the crank seal.

I bet the crank pully bolt is loose. You probably have low oil pressure as well.
:cheers:

If Dan said is correct, then you more than likely have a loose pulley bolt. The gear on the crank is not keyed to hold it in place. It needs the bolt to be torqued to have it stay in place to drive both the oil pump and the powersteering pump. There is no belt to drive the P/S pump on the 1fz engine. later robbie
:cheers:

I just ckecked and you'r right I have low oil pressure. So all I have to do is tighten the bolt .

How does a loose bolt cause this problem?

Thanks,
Vince
 
The oil pump drive gear is not keyed to the crank, it is clamped by the crankshaft pulley. That gear drives the oil pump and the PS pump. That is why the pulley bolt is 16mm in diameter and is torqued to 304 lb-ft.


D-
 
Pyro-Boy - did you ever solve your power steering problem? Curious as to what it was. I just lost mine yesterday. Haven't had time to investigate yet. It's down to -40 degrees Celsius here though and I figure that has something to do with it.

Thanks,
Mike
 
Pyro-Boy - did you ever solve your power steering problem? Curious as to what it was. I just lost mine yesterday. Haven't had time to investigate yet. It's down to -40 degrees Celsius here though and I figure that has something to do with it.

Thanks,
Mike

-40 degrees Celcius! Holy cow; in fahrenheit, that's like, um, -40 degrees! :lol:

(Sorry; couldn't resist a little science geek humor.)

Mike,

Have you looked at other threads as well? Should be plenty of more helpful ones out there.

Edit: Oh, and as a new member, you'd be welcome to start a thread introducing yourself, and you could mention your PS problem there. But beware: if you do introduce yourself, everyone's going to want to see pic's of your rig. :)

Welcome,

Curtis
 
Back
Top Bottom