- Joined
- Jul 9, 2004
- Threads
- 386
- Messages
- 3,997
- Location
- Montgomery Co. TEXAS
- Website
- missionsonwheels.org
I’m swapping a 60 axle into my 40 this weekend and while disassembling the 40 axle to reuse my Newfield’s I found the Newfield race/bearings don’t turn free. It feels like they’re binding inside the bell.
I haven’t cleaned all the grease out yet to see you sure what’s going on, but has anyone had a similar problem? It’s all I can do to move the race and not sure I’ll be able to remove the race and bearing at this point.
These are, I believe, early Newfield’s and the one in question is the short side….. long side is not out yet to know what it’s doing. Longfields are in the future, but not the near future.
Thanks, Mike
I haven’t cleaned all the grease out yet to see you sure what’s going on, but has anyone had a similar problem? It’s all I can do to move the race and not sure I’ll be able to remove the race and bearing at this point.
These are, I believe, early Newfield’s and the one in question is the short side….. long side is not out yet to know what it’s doing. Longfields are in the future, but not the near future.
Thanks, Mike
