Newb differential fluid change

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 26, 2017
Threads
12
Messages
39
Location
Atlanta
I just purchased a 1997 LX 450 for my son. We are trying to baseline the fluids and was curious if there's any downside to changing the differential fluid. Great information here on how to do it, just want check with the experts before we start!
 
Remove the fill plug, then drain, replace drain plug, torque 34ft/lb, fill with fluid of your choice, replace fill plug, torque 34ft/lb.
 
You should change out all the fluids, especially the differentials because they are often/usually ignored.

Just be sure to loosen the FILL plug first. If you can't loosen the fill plug, don't remove the drain plug. That way you can still drive it to someone who can remove both.
 
No need to use hi cost synthetics. They will either get contaminated, leak, or need replacing before the life of a synthetic is up.

Just use the Dino oils. Use 80W90 or 85W90. I have one shop that recommends nothing but DeloLube, but I've used the Walmart cheap stuff as well. Gear oil isn't that complicated.
 
I just purchased a 1997 LX 450 for my son. We are trying to baseline the fluids and was curious if there's any downside to changing the differential fluid. Great information here on how to do it, just want check with the experts before we start!
None at all. The cleaner the oil, the longer the gears last.
 
Can be easier said than done if the previous owner tightened the drain/fill plugs too much. Here's a step by step:

1. Loosen the fill plugs before even going to the store to buy gear oil. If they come loose the rest will be easy. Re tighten before driving.
2. If the fill plugs won't come loose reply back on the forum. There are a handful of ways to get it loose but in doing so you'll probably end up needing new fill/drain plugs (cheap). I ended up needing a 24mm impact socket and an impact wrench (cheap electric one from harbor freight) to get mine loose.
3. Any old gear oil will be fine, I use 75w90 because im in a cold climate. 80w90 would work for you. Have your son remove fill plug, then drain plug so he smells like gear oil instead of you (wear gloves). Replace drain plug when done draining.
4. Use a hand pump to fill it with new gear oil once the old has drained out. Take some photos and post them on here for people to enjoy. Make sure your son does the hand pumping since its time consuming, you can enjoy a beer and watch.
5. Once gear oil starts flowing out of the fill hole its full. Close it up and tighten both drain and fill plugs to 34 ft/lb as @Tools R Us mentioned.
 
Before you even ATTEMPT to loosen fill plugs, grind the end of your socket so you get a "good bite" on the plug. For some satinic reason Mr T made them very skinny!
 
Back
Top Bottom