New here and need help.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 23, 2005
Threads
10
Messages
26
Bought a 75 FJ about a month ago. I'll give ya the details later. Locked the motor up on the way home from Colorado to Ontario.

MAde it about 700 miles and was 8K into repairs, alterations, rad, starter, power steering, disc front brakes etc.

Finished adding Previa seats in the rear, all new weather stripping and some paint this weekend and reassembled.

Anyway, the problem I have now is the signals. Lost the signals this afternoon. No hazards either. Checked the fuse, replaced the fuse.

Any idea where to look. Electrical issues are not my strong point.

Thanks
 
do you know if it's just on the gauges your missing or did you get out and really check them? I've had both problems.
 
Check the hazard switch

I would get out the test light and check that there is power in to the switch. There are going to be two powers in (one from the turn signal and one for the hazards). It's a little hard to explain. Check out the Technical Links Page for a wiring diagram it will help you under stand the wiring for the turn and hazard.
 
No, it is not just the gauges. They do not work on the signal or the harards.

It must be somewhere from the fuse box I think because they do not work left, right or hazards. I assumed there would be two different powers, one for the switch and one for the hazards as you mentioned.

How would I go about testing to see if it is in the fusebox itself?
 
Testing Switch

To test the fuse block, use a test light (you can get one at any auto parts store) to see if there is power on the out power side of the fuse box. you will have to ground the clip on the test light. If the light goes on you have power out to the hazard switch.

The cruiser's have a unique setup for the turn signals and hazards. Both the turn signals and hazards have their own power supply to the hazard switch from the fuse block.

There is one power out of the switch that goes to the flasher relay. This wire is then split, with one end going to the turn signal switch on the column and the other going back in to the hazard switch.

If you have power in to the switch it is probably the switch or the relay are bad.

As I said you should look in the tech links under electrical for the wiring diagram (or get a Haynes Manual) and review it to understand what I'm talking about.
 
Problem solved. HD 12 electrical switch. Seems the PO switched the set up to have the HD12.

ANyway thanks guys. I'll post photos of the truck when I return from a business trip.
 
Appearently it is an electronic signal flasher, relay or something to that effect. I called the mechanic who worked on my rig, who asked me to change it. It looks like a liquid paper bottle with two male connectors on the top, and when the signal light is turned on, you can hear it click.

Anyway, it was like $10 at Partsource. It was with the signal lights, etc.
 
Back
Top Bottom