NEW HD 80 Series Steering, Panhard and Frame Crossmember Kit

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I have one of these on order right now and it definitely looks more stout than I was picturing in my head! Looking forward to getting my swap underway using your offerings!
 
  • Like
Reactions: PIP
Damn. that's a lot of over engineering. Whats the price point on it ? looks like a good alternative for someone who doesn't want to weld. I can't count the # of plate kits I have installed over cracked frames to never have 1 crack again . And we play hard on 40s. For those who might not have experienced that crack yet it looks like this or is in the upper weld . If you have death wobble it's prob this

476833266_567081946332178_8290890070801442949_n.webp
 
Last edited:
raisinhell2 said:
Damn. that's a lot of over engineering. Whats the price point on it ? looks like a good alternative for someone who doesn't want to weld. I can't count the # of plate kits I have installed over cracked frames to never have 1 crack again . And we play hard on 40s
Click to expand...

I think it's gonna be right around $400.

I just added a much larger CNC press brake so I might change the design a little before this hits the market now that I can smash 3ft of 3/8" plate into a small die opening if I want to.
 
PIP said:
I think it's gonna be right around $400.

I just added a much larger CNC press brake so I might change the design a little before this hits the market now that I can smash 3ft of 3/8" plate into a small die opening if I want to.
Click to expand...
$400 is a great price hope you sell a ton of them
 
  • Like
Reactions: PIP
You must log in or register to reply here.

Share this page

Back
Top Bottom