New Front Axle Build ???'s

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 11, 2006
Threads
207
Messages
1,937
Has anyone ever build a front axle starting with a new housing? I got a decent deal on one and plan on using for my OEM locker retro fit.

Just looking at is superfically I have a few questions.

First one is a subject I don't fully understand, shims. Can I just use the ones from the old axle. I am using every thing from the old housing except the carrier of course.

Second, looks like there are races installed in the upper and lower bearing opensings. No sure if these are just to prevent damage in shipping??

Also, the inner knuckle housing is not smooth. The whole housing is painted and its a little rough. Do I need to do anthing to prep this surface or is good to go.

Thanks
 
I'd recommend the FSM as your guide for this task.

1) You shouldn't transfer the shims from old to new without using the SST. Refer to the FSM.
2) The races are for the knuckle bearings. Once again, FSM.
3) Outside or inside. If outside, rough surfaces will accelerate the wear on the rubber and felt seal. No problem if it is rough on the inside.

Have you ever had an axle apart?
 
I'm assuming you're referring to the shims that mount on the knuckles? If so, they should stay with the axle they were delivered with. There is no SST for the 80's axle/knuckle alignment like there is for the 40s.

The races are their for the bearings. You'll replace them along with new bearings - they come as a set from Cdan.

Can't speak for the appearance of smoothness if you haven't seen a typical 80 housing to compare it with.

DougM
 
I have only seen the inside of 60 axle. Looked the same, but I remember the inside the knuckle housing be smooth. I can't really see where it would make a difference.

I have the build kit from Dan, I guess I can check the races against the ones that in there now. They are painted so I assume they are just to protect from damage and need to be R&R.

I'll check the FSM again on the shims.

Thanks
 
I have done this exact swap, a new housing and third and everything else swapped from the original housing.

The new housing does come with trunion races. I left them in place and used new trunion bearings. I also re-used my original shims and the pre-load (at least in my case) was perfect.
You need to treat this like a front axle service and add a diff gasket to your parts list. According to the book you should not re-use the bolts and nuts that fasten the axle housing to the leading arms. Some people do not follow that advice.


Also, the inner knuckle housing is not smooth. The whole housing is painted and its a little rough. Do I need to do anthing to prep this surface or is good to go.

Normal. The outside of the "ball" should be natural as is the inside.
 
Thanks Dan.

I'll check the box of goodies you sent me for the leading arm nuts and bolts. If they are not there I'll be giving you a call.

Yeah, I look through the FSM again and didn't see anything on shimming a new axle. I do as you suggest when I get there.

Jon
 
Back
Top Bottom