Need new front axle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 26, 2007
Threads
7
Messages
36
My Rig was stolen and recovered but has some front end damage. I have taken it to 3 mechanics and all have said that the front axle is bent. So now I'm searching for a new axle or looking for a shop who has the equipment to straighten it. The rig is a JDM import with front and rear lockers and I believe that the North American fj80 from 1993-1997 share the same axle. What do you guys think is the best and cheapest solution? Try to find a replacement or have it straighteded? Here are the alingment numbers ( not that they make any difference at this point)

Camber: left front -1.7* Right front -2.9*
Caster : left front -0.1* Right front -0.8*
Toe: left front -0.06* Right front -0.8*

So if you have a spare front axle laying around or know where I can get one ,Please let me know. I live in Alberta Canada so that makes things a little more challengeing.
 
A JDM vehicle would be right-hand drive. Left-hand drive axle housings will not fit. The panhard mounts are backwards.
 
A JDM vehicle would be right-hand drive. Left-hand drive axle housings will not fit. The panhard mounts are backwards.

Couldn't a competent fab shop put the panhard mount on the correct side?

Plus, I'd reuse as much of the original as was salvagable.
 
If you could find an axle housing that came with lockers and fab up the panhard mounts it would be alot cheaper than paying for a complete axle. The locked axles seem to bring about $1200.00 For the front.
 
your best bet would to be try to find someone in canada with the axle. based on what cdan said...I seriously doubt that you'd find anything serviceable in the the states.
 
Couldn't a competent fab shop put the panhard mount on the correct side?

Plus, I'd reuse as much of the original as was salvagable.


I have not had the pleasure of having an LHD and a RHD axle housing side-by-side to be able to determine if one could cut the important bits off of one and transfer them to the other.

Since the number of RHD 80's in the US could probably be counted on one hand ric80 would be better suited to make the comparision.

The orientation of the panhard mount is critical to correct housing orientation and steering performance. Do bear this in mind when you consider modifying an LHD housing to RHD configuration.
 
Last edited:
Talk to a heavy truck/equipment service facility. They have the resources to straighten an 80 axle housing. Forget about automotive shops - go to the guys who service Caterpillar/Harvester, etc for the logging and mining industry.

DougM
 
Thanks for all the replies. I havn't had a chance to read the forum for a week or so because my mother just passed away. Could a hard hit to the wheels knock the kingpin bearings out and cause this negative camber and caster? When I first jacked the truck up and lifted the tire with a long pry bar I heard a clunk and the tire shifted a little more positive camber.
 
Last edited:
If it moved something is broken. You will ned to tear it down and find out what it is. You would need to fix the broken bits and then see what that gets you (unlss the housing is visibly bent).

Sorry for your loss....:frown:
 
Back
Top Bottom