Need help installing new OME greaseable spring pins

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 6, 2005
Threads
9
Messages
197
Today I was upgrading from stock pins and shackles to greaseable OME parts. Everything came apart smoothly since somebody put polybushes on at some point. The shackles went on quite slick, and once I got the holes in the spring and the spring hanger lined up the pins went in fine...all except for the round 1/8th inch thick plates that should fit into the outward sides of the spring hangers. Has anyone run into this before? I have tried tightening the spring pin up, jacking the truck up and down, and beating on it with a wooden mallet. I was thinking about trying a pipe clamp next to try and squish it in there.

Anybody have any good magic tricks for getting the pins to go in there?
(Yes, I did try to search for info on this)

Thanks
 
If you are trying to do this after the axle is attached to the springs and so on, you are in for a fight.


These are installed before anything else is attached to the spring, because as you are finding out, there can be issues with getting these spring pins to line up in the frame hanger. You need to be able to twist the spring, either by using a very large cresent wrench, or a large rod through the other end of the spring, to try and get it up into the correct spot. You can try jacking up on the spring, just below where the spring pin will attach it to the frame, but be mindful of the fact that you are loading up your jack on a surface that is not square, so it may want to move on you.


It is still a design one thousand percent better than the bushings that are pressed into the frame on the Series Rovers....



Good luck!


-Steve
 
It is still a design one thousand percent better than the bushings that are pressed into the frame on the Series Rovers....



Man, your'e not a kiddin'. Removing old Rover frame bushings tops my list of least favorite activities.

Installing the pins first does make the most sense. I'm not replacing springs, so I didn't undo any U-bolts. The big wrench on the end of the spring sounds promising, I'll have to give that a whirl tomorrow.

Thanks
 
i've always done fixed side first, then shackle. allows for easier movement. also, get it snug, then whack the edge with a hammer in the direction it needs to move.
 
Mine went in like butter but that's w/o the u-bolts attached....I say if it doesn't go in within 10 min...unbolt the u-bolts and go from there.

Once I got enough of the threads through the hole....I used the nut to pull everything nice and snug.

I also used a jack to hold the spring at the optimal height.

Good Luck
 
Well, it turns out that my pin problems are a bit more fundamental...

IMG_0018.jpg

IMG_0017.jpg


ARB sent me GP2 spring pins instead of the GP1 pins that I ordered. There isn't a huge difference between the two, just enough to not work. I should have checked my order a bit better! :doh:

Needless to say that my stock spring pins went back on smoothly...
Thanks for all of the suggestions.
 
It could have been worse:


You could own a LandRover & ARB could have supplied you with the wrong spring bushing parts. :D
 
Shaun, did you get the GP1's... if your in a bind I have them here in town and you can just get me yours when they arrive. The GP2's with the bigger "spigot" size are for the 75 Troop carriers.
 
Back
Top Bottom