Need help identifying this electrical plug thingy...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 21, 2016
Threads
24
Messages
215
Location
Statesville, NC
Hey folks,

Can someone help me identify what this electrical plug thingy is, so I can try to look up a part# and get a new whatever it is?
It's directly related to the engine idle, as sometimes my idle will drop down real low and I have to put my foot on the pedal to keep it from stalling out. And if I open the hood and tinker with the wires coming out of that plug, the idle goes back to normal but only when I *hold* the wires in a particular way (ugh!). So, at least I found out "well there's your problem..." I just need to know what it is. ;)

Much appreciated, and thanks for any tips!!

IMG_3078.webp
IMG_3079.webp
 
You can use a pin-setting-tool-a-majigger from harbor freight to reengage those wire. Add a little solder and you're good to go.

It may be simpler fixing the wiring than replacing the part.
 
You can use a pin-setting-tool-a-majigger from harbor freight to reengage those wire. Add a little solder and you're good to go.

It may be simpler fixing the wiring than replacing the part.
Thanks- I'm a little less knowledgeable on tools - can you describe that pin setting tool a little more (does it have a different name?) so I know what to look for at HF? Thx!
 
You need either new plug, or reuse that one but either way you have to de pin it, Google wire pin tool, that is tps sensor
 
You need either new plug, or reuse that one but either way you have to de pin it, Google wire pin tool, that is tps sensor
Ok thanks - I'll give that a shot since I can't break it ;). I'll also look up that TPS sensor wire harness too. I appreciate the info!
 
You can not buy just tps sensor wire, you can get the plug but you will have to de pin your old one then re pin the new one, if your plug is not broken repair those wires and re pin it
 
Yeah, what they said.

And yes, that does affect your idle. I just had issues with my TPS but @MDarius came through in the clutch. He might be willing to cut off his plug with 5-6" of pigtail and sell it for a fee. Then solder it back in to the wiring harness with shrink tubing over it. That would probably be the easiest thing to do. Plus your connector is busted up.

That's what I would do.
 
I would crimp it not solder it back in I work aviation private jets and we use a double crimp tool hardly ever solder anything if it's by any heat or vibration cause it will break the solder
 
The FSM can help you understand how to rebuild the connector. That's what I would do. It looks like those wires have been "repaired" before. I'd hate to cut a connector off a perfectly good wire harness.

I would test for resistance in the wire from one end to the other. At 20+ years old and running through the engine bay it may be a bigger problem than just right at the connector. May as well check it while you're doing the work.
 
Back
Top Bottom