Need Help ASAP

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 22, 2016
Threads
55
Messages
232
Location
On the road
Website
www.nextgenoverland.com
I am in south texas just nw of big bend on a gravel road and my brakes have failed. The reseviour is full and about to pop, the pedoe goes to the floor but if i pump it a lot i get minimal brajing. what happened what can i do to fix, suggestions on where to go to get it fixed?


also, while typing this, and sitting the brake pressure returned. My guess is a siezed caliper, passenger rear siezed overheating the fluid?


thoughts?
 
Just did a quick Google search near Big Bend. Not sure how far this is from you but it gets good reviews.

Google Maps
 
You said the reservoir is full (over flowing?)
That usually happens if the caliper pistons are pushed all the was back into the caliper, like when your putting new pads in.

I would suggest looking that the wheels and make sure that they are not wobbly. A wheel wobble will cause the pistons to be pushed back into the caliper and cause the symptoms you are saying. The brake peddle going to the floor is caused by caliper pistons being completely pushed into the caliper.
If pumping the brakes makes them work again, that is also a sign of a wobbling wheel.

If they are wobbling, take off the little axle covers from the front hubs, and make sure that the axle nuts have t backed out. Or see if everything looks straight. If the bearings go out. It will cause the wobble

If you can’t tell by looking at the wheels if something is off, you may have to jack up the wheel to see if there is a problem.

If the bearings are the problem. There is not a ton you can do on the trail. But if you carry a 56mm socket (I do because I’ve had to replace birfields in the trail)
You can tighten the wheel enough to limp back to a place to fix your truck. Or if you have needle nose pliers, you can jack up the wheel and use them to tighten the nut, but it is not easy and only works so well.

Good luck
 
Ok I am now in Alpine TX.

1. Fluid returned to normal location at Max as things cooled down.
2. Brake pedal is not stiff, goes halfway down before i get decent braking. I can lock up at this point.
3. When the engine is off I make the brake pedal stiff
4. When driving it takes a bit of pumping to get the brakes hard....
5....at that point the rear passenger wheel brake starts squeaking
6. In a half mile the pedal is soft again

A. There is no unusual handling characteristics
B. No loss of fluid

I have a set of rear calipers and pads ordered from O’Reily. They will be here on Tuesday. Hopefully they come and can find a place to install them on Wednesday.
 
Pull the wheels off and at least check/compare the pads on both sides. A sticking caliper will cause one side's pads to wear a LOT more than the other. A sufficiently worn rear pad can slip out of the caliper assembly...

cheers,
george.
 
I lost my brakes going down Rose Garden hill in Moab and the brake fluid was boiling and reservoir overflowing. I change brake fluid and the problem was solved. The old brake fluid had absorbed so much moisture it started to boil from the heat comming of the exhaust manifold.

Good Luck.
 
If you can figure out what brake is bad, I would take a small set of vise grips, and pinch the brake line (you do have tools.... right?) that way you won’t lose fluid, or overheat your fluid. Just BE CAREFUL, because if you do this and jump in the brakes, it’s going to pull BIG TIME....... slow and steady..... good luck!
 
Update,

I was looking at my FSM and did some troubleshooting. It seems to fail the booster test. I’m really tired and frustrated tonight so my mind might be jumping from one thing to another. I cant lock up the brakes anymore, but they do engage @ pedal 3/4 travel to the floor and stay there. When they say brake pedal to the floor is it really to the floor. No experience here so seeking it from those who have it.
 
It honestly could be anything. You may have a bad master cylinder, a bad caliper, loose wheelbearings, air in your lines, etc. We are not going to be able to tell you over the internet.

What I can tell you, is that the brakes are the most important part of your vehicle. Without brakes, it's a 6000 pound missile. DON'T DRIVE IT. Settle down, go have a beer, and either have it flat bedded home, or wait until you can get it looked at.

What I would do if it were me, is to bleed the entire system, each wheel in turn including the LPSV. That will allow you to inspect everything, change the fluid, get any air out of the lines, and have some sense if the master is at least moving fluid through the system. That could solve your problem with tools and stuff you may have at your disposal. If that does not work, it doesn't sound like you will be able to fix it yourself. No offence, it's just the way you are going about this, suggests brakes are new to you.

DO NOT DRIVE THE TRUCK WITHOUT WORKING BRAKES
 
Unfortunatly, this is not a typical case. It IS my home and as such I dont have the luxury of not driving it and flatbedding it anywhere. I need to drive it to the shop etc. Just happy its not worse. You are right, I don’t know much about brakes. I’ve only replaced calipers multiple times on my past Jeep TJs, rebuilt the brakes on my Willys MB, Done countless pad/rotor jobs. This situation is though as I have never had a master cyl, booster go or had fluid go to the top of the res. Like I said, new
 
Unfortunatly, this is not a typical case. It IS my home and as such I dont have the luxury of not driving it and flatbedding it anywhere. I need to drive it to the shop etc. Just happy its not worse. You are right, I don’t know much about brakes. I’ve only replaced calipers multiple times on my past Jeep TJs, rebuilt the brakes on my Willys MB, Done countless pad/rotor jobs. This situation is though as I have never had a master cyl, booster go or had fluid go to the top of the res. Like I said, new


Great! Then go bleed the entire system (don't forget the LPSV) and report back.You can do this in an hour with a quart of brake fluid. You might get lucky.
 
Back
Top Bottom