My Rolled 80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Sorry to hear that you Beno'ed your truck! It would suck to no end if that was me for sure.

On a positive note, I'm glad that you and your passengers were safe!
 
Been there. It sucks but you get through it. Rolling my truck for me was a blessing in disguise . Nice to see you are still smiling.
 
Been there too. :mad: Glad you're in one piece. To add to your seatbelt comment. Ditto the windows. Even though it is futile, its tough to resist the urge to put a hand out and try to hold the truck
up. :doh:
Windows keep the limbs inside....and attached.:bounce::bounce2:
 
glad to hear you are ok. The dunes are a strange place to drive, especially if you are not used to it. I almost rolled my 4runner there a few years back, my right rear was about three feet off of the sand and my wife was holding the roof, and quite upset. When I pointed the wheels at the bottom and let off the brake all went well. The secret seems to be to keep it pointing up or down, not sideways unless you have some speed behind you.

So do you have any idea what caused you to roll? Maybe this can be a learning experience for everyone.
 
Sorry to hear that you Beno'ed your truck! It would suck to no end if that was me for sure.

On a positive note, I'm glad that you and your passengers were safe!

Man, here I am having become a "verb" again.....

I think it's an indication that I need some time away....

Sam....you know where I stand. Keep the faith brother. I like Al's idea the best. The Ride of the Valkyries.....

-o-

PS: the 80 series rolled list has gotten pretty deep...Wrench, Kliers, the kid from Truckee, the dude that did the full speed jump off some small cliff in the desert, me, am I missing anyone?
 
Last edited:
Who was the guy who flipped his over the concrete divider on a highway? He didn't like ABS and drove with the CDL on... but not ST.

Wasn't there a younger guy who flipped it over on top of a wooden canoe that was on the roof while backing up to turn around?

Does the U haul trailer hauling a 55 behind an 80 count?

Yeah. Getting to be a long list. Almost needs an entry in the faq. Something along the lines of, 'slow down and be careful'. Not that it would have made a difference in some cases.
 
Who was the guy who flipped his over the concrete divider on a highway? He didn't like ABS and drove with the CDL on... but not ST.

Wasn't there a younger guy who flipped it over on top of a wooden canoe that was on the roof while backing up to turn around?

Does the U haul trailer hauling a 55 behind an 80 count?

Yeah. Getting to be a long list. Almost needs an entry in the faq. Something along the lines of, 'slow down and be careful'. Not that it would have made a difference in some cases.

That was Beno

That was me, but it was my second time over with that rig. The first was on a trail

I forgot about that guy--Cruiserguy's son in law or something, nickw was the screen name.
 
funny, I got pm'd by a guy today that wanted to sell me springs off of his recently flipped 80. i think I am going to do the "keep it on its wheels dance" before getting into my 80 every time.
 
Who was the guy who flipped his over the concrete divider on a highway? He didn't like ABS and drove with the CDL on... but not ST.

Yeah, that was me.

ABS wouldn't have helped even if I did have it. I went full speed right into a snow bank and over the divider. I did have the CDL engaged in H.

The other option would have been being crushed to death by an 18 wheeler. I think I made the right decision.
 
Since you all have my brain running in high gear I'll pose a question. Given the choice would you go Exo or internal cage? (explain your preference. (If I go internal the tube will follow the A pillar through the dash to the frame, no bends around the dashassuming that the body is left as is....rear end is untouched.
 
Since you all have my brain running in high gear I'll pose a question. Given the choice would you go Exo or internal cage? (explain your preference. (If I go internal the tube will follow the A pillar through the dash to the frame, no bends around the dashassuming that the body is left as is....rear end is untouched.

I doubt either would have prevented much of what happened to your rig for that kind of roll. I think an internal cage can be made much stronger to protect the occupants because it is fairly easy to tie into the frame, but they really are a PITA to live with on a daily driver and you'll get no body protection - you sacrifice cosmetics to ensure you live.

Question on an exo is what do you tie it into and how so that it is really strong enough to hold up in a violent roll.

Having done an internal cage on a daily driver before, I came to doubt the value - it was the point where I realized I had gone too far. Unless you are bolting in some offroad/racing seats with five point harnesses and tying it all into the cage, I think these are half measures that devalue the daily under the premise of being able to handle a hard roll (you already know your rig can handle a lighter roll in the sand) where it may be other things that are at issue like a 3 point seatbelt holding you in properly where the roll is violent.

If I was expecting to roll, I'd go all out with the five point harnesses and internal cage, but then I'd also be driving a buggy and not an 80.

Good luck - worth giving it some time to see where you end up. I almost rolled on my last major run, and it's taken a lot of the hardcore rock crawling drive out of me. When you find your limits is when your projects usually take a turn one way or another.

Good luck with it either way :cheers:
 
well ide say to kinda carry on with what Nay said you'll loose space with intro cage so go exo/intro. it's not like your body's mint any more any way so do a good exo tied to bumpers and sliders then somthing that comes down through the top and ties into the frame and you can always do your seat.seatbelt mounts off those some how also..... my .02
 
Since you all have my brain running in high gear I'll pose a question. Given the choice would you go Exo or internal cage? (explain your preference. (If I go internal the tube will follow the A pillar through the dash to the frame, no bends around the dashassuming that the body is left as is....rear end is untouched.

exo is a weaker design but will protect the body in a light roll. I suggested a internal since your body is already messed up and the fact the internal is much much stronger.
 
I guess the guys at LINK will have a new pony in their stable pretty soon huh?

Smit
 
you had to bring link up..... ummm I think sammy would be better off buying a 220V welder and a tube bender, and i will help him build a cage/back half 80.
 
you had to bring link up..... ummm I think sammy would be better off buying a 220V welder and a tube bender, and i will help him build a cage/back half 80.

I guess I am missing something Ian. Hope I did not offend anyone. If there is a story, I promise I don't know it.

Only thing that I can speak on LINK about is that they cut some 1/4'' steel plates in half for me one day. Only took 30 seconds and they did not charge me.

Smit
 
Sam and I had the opportunity to talk at length Saturday and Sunday. He's an amazingly mature young man that will go places, make something of his life and learn from this experience.

Sam - just tell your parents about all your 50 year old friends doing this and they may understand that it's something you will never grow out of!
 
Back
Top Bottom