My P0401 saga

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 13, 2008
Threads
38
Messages
350
Location
Boulder, CO
I have posted this in a couple other threads but I thought I would throw up another thread for those that get the P0401 code. I also developed a rough idle only in park or neutral and only when the truck was warmed up. I don't have any pics for this, sorry I was in a hurry and was trying to beat bad weather and darkness.

I was throwing codes only when I got the truck over 70mph for a sustained period. It would never come on when I drove it short distances. This sounded like from my searching, and Raventai and Beowulf's posts to be an intermittent VSV for EGR failing when it got hot.

I tried the VSV replacement without taking the intake manifold off as others have done and it ended badly. I ended up spinning the head of the bolt for the VSV (the one you access from the DS).

Yesterday I took the intake manifold off and replaced the VSV for EGR, and the fuel filter. The bolt came off easily once I got a socket on there. The intake manifold and EGR valve had a fair amount of carbon buildup. I am cautiously optimistic that the rough idle is gone. I will post back when I get it on the highway to test for the code. I still have the old VSV so maybe I will test it someday when I have time but not right now, I am enjoying driving it after I had it in a bunch of pieces yesterday. Sorry no pics. Thanks to all who gave advice!
 
I am an advocate of splitting the plenum to do the job and replacing the vacuum hoses while you are in there - it just makes all kinds of sense to me.
 
Anyone have a list of all the parts needed for this job (splitting the plenum and throttle body), like all the gaskets (throttle body gaskets too?), all those little hoses under the intake? Anything else to replace or clean or check while it is apart?
 
Anyone have a list of all the parts needed for this job (splitting the plenum and throttle body), like all the gaskets (throttle body gaskets too?), all those little hoses under the intake? Anything else to replace or clean or check while it is apart?

The pros will chime in I'm sure, but I did:

TB clean (I already did this a month ago)

TB gasket

Vacuum hoses all around

Get some bigger tubing, I don't know waht this tubing is called but I didn't have any I have a few hoses that are cracked that I am going to replace next time I go in there.

Intake manifold gasket

EGR gasket

Fuel Filter

Everyone says to do the injectors while you are in there, I did not have time to send them out, but once the manifold is off they are right there.

I'm sure there is more, that's all I can think of for now.

Enjoy!
 
Kernal said:
Anyone have a list of all the parts needed for this job (splitting the plenum and throttle body), like all the gaskets (throttle body gaskets too?), all those little hoses under the intake?

Everyone says this all the time - and for a good reason: "Call CDan at American Toyota, for the best prices on OEM parts and the best knowledge." Dan will fix you right up with everything you need, just tell him what you are doing to the cruiser. You can find him in the vendor section.

Kernal said:
Anything else to replace or clean or check while it is apart?

The PHH comes to mind as well as cleaning out the throttle body. Find all you need to know about the PHH in the FAQ.
 
Back
Top Bottom