mud flap help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 16, 2010
Threads
4
Messages
11
80 series cruiser-the driver side rear wheel house has a plastic trim piece that lines the back of the wheel well and also attaches to the mud flap to help secure it in place. Can some one tell me if the right side has a similar piece??? Any assistance greatly appreciated!!
 
yes if it is what I am thinking of. do you have a picture? I may have one if you need it.

IMG_5656.webp
 
See the hole w/o a screw. The little plastic wedge behind where those other screws are is in place it just seems as though something else should be there to secure the mudflap to the wheel well. It's very loose
 
There is a plast
See the hole w/o a screw. The little plastic wedge behind where those other screws are is in place it just seems as though something else should be there to secure the mudflap to the wheel well. It's very loose

There is a plastic bracket with 4 holes between the mud flap and body. I think 2 holes attach to the mud flap, 1 just to the body and one to both the flap and body, at least on my 93. Here are the two that came off my 93 when I pulled the rear flaps (zip tied to a flap for storage), one on each side. If you pull the "good flap on your rig you will see what I mean. Both sides are the same, just mirror image, i.e. left and right.

20161012_193514_resized.webp


068.webp
 
Sorry about the extra picture. I was testing to see if I could attach a picture before I took the trouble to dig out the part and take a picture and I can't figure out how to delete the test one :). At least it is work safe.....
 
I do have that plastic piece in place. The flaps appear to be a mirror image however on the drivers side one bolt also goes into a larger piece of plastic trim that covers the gas fill lines. That plastic piece helps secure the mud falp. I was wondering if i was missing a similar trim piece on the passenger side. Thanks for the response
 
Sorry I'm not more help. its been too long since I pulled mine the rest of the way off for a labs 4x4 rear bumper.

I thought you might be missing the plastic piece I mentioned. Good luck
 
When I removed mine using a 40" tire stuffed up in there with some assistance from the rear locker. They were just a Plato. Piece with little metal clips that screws thread into just like you have pictured. I made new ones from 1/8 mile steel and they worked well for a bit, but eventually I just opened the wheel wells up.
 
Back
Top Bottom