Mounting rear seat???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 17, 2002
Threads
68
Messages
421
I have been looking into putting a rear seat into my 40 since my wife and I now have a daughter. I was walking to the coffee shop the other day and bought a Beard bench seat froma neighbor for $5 and now want some thoughts on putting it in. Should I have a basket welded up and mount the seat into the roll cage or make some brackets myself and mount it to the floor? Is the floor strong enough to hold the seat during an impact? I noticed that a lot of the aftermarket seats mount to the floor or fender wells. If it's mounted to the floor I can remove it when it isn't needed and still pack all my gear in the back. Let me know your thoughts.
 
There are a bunch of threads dealing with adding a rear bench seat. I'd probably opt for bolting it to the floor or fender wells, but I recommend reinforcing the mounting points. Also, make sure that the top of the baby seat does not extend past the roll cage. The cage needs to fully protect the seat in case of a roll-over. Finally, it goes without saying that the safety of your daughter is of utmost importance. Don't take shortcuts during the install.

Good luck and post some pics when you're done.
 
Back
Top Bottom