More Magnets!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 27, 2003
Threads
37
Messages
6,206
Location
uhhhh...duh...Northern CA
Okay, so we all know that fuel line magnets are worthless -- except those on Junk's hoopdee -- but what do you think about these magnets that fit around the oil filter?

Check 'em out here: Filter Mag (yeah, yeah, I know...it's a Rover site...)

A bit on the pricey side...

Do you think it would make a significant difference or are magnetic drain plugs "good enough"?

Whaddaya think?
 
Snakeoil, Doug.


Pistons = non-ferrous.
Bearings = non-ferrous.
most other wear-points = non ferrous.
big chunks of connecting rods = ferrous :eek: (likely to fly out the side of the block before reaching the oil filter :D )
 
I am a firm believer in drain plug magnets, they do remove iron particles from the oil and are a more effective use of your money that a filter mag

1. Filter mag is expensive, this money can be used for other more useful mods
2. You are putting a lot expensive magnets on the other side of a piece of steel from the oil, this greatly reduces their effect, the majority of the magnet flux will travel along the steel shell of the filter like a short-circuit
3. You are trying to pull very fine iron dust (anything larger than 35 micron the filter will catch anyway) out of moving oil, not the best place to do so
4. The Neodymium magnets that filter mag uses do not stand up to heat and will degrade quickly when exposed to oil temps, super plug also used these


Did some measurements a few oil changes ago, a 3/8 dia cylindrical magnet (AKA disk magnet) of at least an inch long can be put on the factory drain plug with no interference,

You can buy Samarium Cobalt (SmCo) magnets in many shapes witch are almost as strong as Neodymium magnets but hold up to much higher temperatures, getting one to epoxy to one to the stock drain plug will cost less than $15 w/shipping

Plan to do this some time, have not gotten to it yet,

If you must have a magnet on your filter you can get Neodymium magnets cheaply out of old hard drives or online surplus and just stick them to the outside of the filter

More reading lots of different opinions


Filter-mag

http://theoildrop.server101.com/cgi/ultimatebb.cgi?ubb=get_topic;f=6;t=000022
http://theoildrop.server101.com/cgi/ultimatebb.cgi?ubb=get_topic;f=6;t=001114
http://theoildrop.server101.com/ubb/ultimatebb.php?ubb=get_topic;f=6;t=001051



Magnetic drain plugs

http://theoildrop.server101.com/cgi/ultimatebb.cgi?ubb=get_topic;f=24;t=000946
http://theoildrop.server101.com/cgi/ultimatebb.cgi?ubb=get_topic;f=6;t=001565

Lots more info if you search over there
 
They clame the magnets catch particles around the 2 micron size.
That is very small indeed and I expect an engine really doesn't care about such small microns.

Anyway when you eventually suck out the oil, I think the microns just hitch the ride into the waste oil container.

If it would be that big a benefit, I think most engines manufacturers would build OEM magnets into the oil circuit.
 
What about the magnet that came with my LRA aux gas tank with instructions to put it as close as possible to the line that suck gas and feed the electric gas pump input ( I added before the pump input a marine gas filter with a tempered glass cylinder which allows me to see the trapped particles ) ?

Does it really catch the metal particles that are released from the oxidation of the aux tank welding points and the metal particles that came from the gas station tanks ?
 
Last edited:
What about the magnet that came with my LRA aux gas tank with instructions to put it as close as possible to the line that suck gas and feed the electric gas pump input ( I added before the pump input a marine gas filter with a tempered glass cylinder which allows me to see the trapped particles ) ?

Does it really catch the metal particles that are released from the oxidation of the aux tank welding points and the metal particles that came from the gas station tanks ?

I'd forget about the magnet, the marine gas filter probably will do the trick more than adequatly.
 
Back
Top Bottom