Moly or Metal?

[Tools R Us]

In the first pic, can see the line where the grease level is. With one this low, I would add 1/2 tube the first time, then 1/4 each time to bring it up to the proper level.

When assembling an axle seal job, it is difficult to accurately fill to level. I always drive them a bit, then adjust the level. Most that I have seen are way low, even only a few months after the job.

 

[atomicshawn]

I have now been properly schooled in birf grease supplementation. Thanks as always Kevin!

 

[cruiseroutfit]

I replaced the axle seal thanks to Kurt at Cruiser Outfitters who I think had the only 80 series front axle seal in Utah!... pretty fortunate to have that resource...

Glad it worked out, thanks again for all your business Shawn!