Missing hub snap ring...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 13, 2008
Threads
74
Messages
289
Location
stuart island BC canada and Costa Rica
So I tackled my leaky hubs today, and I think one of my chickens stole the snap ring that goes on the axle shaft, under my free wheel hub body. I finally just wrapped some stiff wire around the groove and buttoned it up. I need to drive it to town (20 clicks on bad dirt.) to get a new clip It should be fine right. It's not like the shaft can go anywhere. Thoughts please, I don't want to wreck it.
Don M
 
Anyone have any input? Am I ok to drive it this way?
 
I would drive with it depending on how thick the wire is. Just don't try to drift too much...
 
Thanks Oscar, That mas my thought too. It's not like the axle can go anywhere.
 
I had the same issue with mine as well...you may find if it gets past the wire you will have to thread a bolt into the shaft and pull it out more to get it to show the groove for the new ring. Having the hub cover off with the tire bolted on still make it easier to get the shaft to pop out and in place if need be. Don't forget the cap and some moly grease too.

CS
 
I know the farm critter issue with parts. My last goats opened s side door to my barn where head parts and hardware were and threw cam caps and bolts all over out side. I couldn't use wire on the cams. When you get to town, find a place that has external snap rings. I use two per stub shaft and they're way easier to get on and off than the stock snap rings.
 
Thanks for the replies , I feel better about the prospect of driving her now. I'm thinking chicken for dinner tomorrow.
 
I did some hub work on mine and drove it to Arizona and back (1600+ miles) before I realized my snap ring was missing. Didn't seem to cause any harm, I'm sure 20 miles will be fine.
 
Back
Top Bottom