Minitruck knuckle washers

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 9, 2003
Threads
151
Messages
2,259
Location
Lancaster, PA
All,

It has been a while since I tore apart the minitruck axle that was the donor for my disk brake swap.

I have both flat washers and locking washers for the steering arm and bottom plate and don't recall where each goes.

Does anyone remember the configuration?

Are the flat washers for on the cone washer, and then a lock washer?

Thanks!
CAZ
 
I'm pretty certain the non-split flat washers match up with the cone. That's the way all of mine are set up. The split washer goes with the bottom plate. Confirm in the FSM but I'm very confident about this. Honestly, though, I don't think it matters that much.
 
Cruiserdrew is right, I looked at the diagram at the dealership and they ordered me new washers for the top and bottom. Top gets cones, then hardened flat washers. Bottom gets hardened split.

Probably could get them cheaper at a hardware store, but most of the washers that I have replaced off the cruiser seem to have a larger outside diameter than the ones on the truck. As you know, these four bolts are close together and need to be the right size to keep them from touching.

Jeremy
 
I can't tell from the FSM pictures either but it is the steering arm nuts that always seem to backoff allowing the studs to shear. You never hear of the bearing cap nuts backing off. Not sure how it came from the factory but it makes sense to me to use the split washer on the steering arms and the flat on the lower bearing cap. That is how I set mine up and I check them daily while wheeling for proper torque.
 
It makes sense that the steering arm nuts can back off, they are getting all the torque. It also makes sense to have the flat hardened washer on the cone-the cone acts as a lock. I am certain about the order-the split washer goes on the cap, not on top of the cone.

I check mine every day too when wheeling. Since Toyota went to the studs with the torx drive on top, and you can get them really tight in the knuckle, I rarely have to snug them up anymore. They stay tight.
 
I noticed the same thing once I installed the torx head studs. My steering arm nuts only backed off once since install. What you say makes sense about the flat washer against the cone washer. I wonder which washer is more prone to allowing the nut to back off? I also red Loctited in the studs which I think makes a difference.
 
Last edited:
Back
Top Bottom