Measuring axle location

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 7, 2004
Threads
86
Messages
1,447
Location
Reno, NV
With all the recent talk about Panhard Rods, I'm wondering how people are measuring just how off center their axle's are, and at what amount of movement should you be addressing it with adjustable rods? I have been reading through some archived threads recently and it appears that most at my height, OME heavies would not need to adjust the rods? Lastly, since the axles are pulled to opposite sides of the truck, can that affect the tracking of the truck on the highway?
 
When I installed my Slee 6" system, I taped a plum bob off the front fender flare on each side and adjusted the panhard bar until I had equal distance from the line to the end of the front axle drive hub. I used wratchet straps to pull the axle into place and hold it there as I adjusted and installed the panhard bar.
 
on the rear I just measured from the frame out to an outside tire lug. Just make sure you use the same lug on each side.

I can't remember what I did on the front. I think it was something similar to the rear just measured from underneath.

The ratchet strap is a good idea, the rear is a real PITA to get over where it needs to be.
 
on the rear I just measured from the frame out to an outside tire lug. Just make sure you use the same lug on each side.

I can't remember what I did on the front. I think it was something similar to the rear just measured from underneath.

The ratchet strap is a good idea, the rear is a real PITA to get over where it needs to be.

Rick - Which MAF drop bracket did you use? 4" or 3"? It appears that now they only make the 4" but I could have sworn at one point they made a 3". I'm not even sure yet I need to do anything with mine, but if I do, I was hoping to do the rear with a the MAF bracket, but I think the 4" would be overkill for my application.
 
I used the 4" bracket for mine. From another thread I'm going to look into making a lift bracket for the axle to do the same thing. It's just right now I'm trying to finish up a summer project of residing the house.

If you get the MAF bracket give me a shout before you install it. It took me two tries to get it installed correctly. For what ever reason they don't provide instructions with their stuff.
 
I used the 4" bracket for mine. From another thread I'm going to look into making a lift bracket for the axle to do the same thing. It's just right now I'm trying to finish up a summer project of residing the house.

If you get the MAF bracket give me a shout before you install it. It took me two tries to get it installed correctly. For what ever reason they don't provide instructions with their stuff.

I think I read through that thread this morning ..... sounds interesting, if you need a tester for your beta version bracket let me know :D, I think that the MAF 4" would push my rod back past center, thus not doing me much good really.
 
Back
Top Bottom